Camerons Products MSC-2769-SLD owner manual Tightening Nuts & Bolts

Page 4

'_kWARNIN_ Instruct children not to attach items to the playground equipment that are not specifically

designed for use with the equipment, such as, but not limited to, jump ropes, clothesline, pet leashes,

cables and chain as they my cause a strangulation hazard.

Lawn swings, if applicable, are designed for use by children two years of age and older. The use by children

under the age of two can result in entrapment between the seat and back rest because the child's body may pass

through the opening, causing entrapment of the child's head. Such entrapment may result in strangulation.

NEVER place children in a rearward facing position or with legs between the seat and backrest.

_k WARNING Instruct children not to go down slide head first.

_WARNING Check slide bed for extreme heat before letting children use slide ( When exposed to direct sunlight )

A/

AWARNIN_ Do not allow children to climb on swing from structural members (Legs, top bar and chin bar).

These are structural components only and NOT play features.

If there is any cracked or damaged parts, do not use this equipment; call the 1-866-884-0535 number for

replacement part.

Please save this instruction manual for future reference and review each season.

Plastic components should be replaced every three years.

TIGHTENING NUTS & BOLTS

At the start of assembling, do not tighten bolt/nut all the way, so to allow some possible adjustment, for ease of installation.

After all major components are assembled, go back over all bolts and nuts and properly tighten all of them

before using this product.

CARE & MAINTENACE INSTRUCTION

Check all nuts and bolts twice monthly during the usage season for tightness and tighten as required. It

is particularly important that this procedure be followed at the beginning of each season.

Oil all metallic moving parts monthly during the usage period.

Sand rusted areas on metal tubing and repaint using a nonlead-based paint meeting the requirements of Title 16 CFR Part 1303.

Check swing seats, ropes, cables and chains monthly during usage season for evidence of deterioration.

Replacement should be made in accordance with manufacturer's instructions.

Check all coverings for bolts and sharp edges twice monthly during usage season to be certain they are

in place. Replace when necessary. It is especially important to do this at the beginning of each new season.

Remove plastic swing seats slide and take indoors or do not use when temperature drops below 32 degrees F (0 degrees C).

Disposal Instructions

+Please use with care to disassemble the unit, when it is no longer in operational condition. Wear heavy duty working gloves!

+Consumer may wish to recycle the steel tubing, please take the frame to your local recycling center.

+Be sure to completely disassemble the whole swing and slide sets, before disposal.

+Do not leave partially disassembled equipment in area where accessible by children.

+All plastic parts could be recycled, take it to your local recycling center.

+All rusted parts, bolts shall be properly disposed of in trash bin. Do not reuse.

"_ Do not let children play with any disassembled parts destined for disposal, such as chain, slide, tubings, bolts, nuts, screws!

Image 4
Contents MSC-2769-SLD Cameron General Instruction Waing Tightening Nuts & Bolts Consumer Information Sheet Hardware Actual Size but for Reference only Bracket used for glide ride assembly Hardware used for slide assembly Tools needed for assembly Hardware used for main frame assembly Parts used for swing seats assembly Parts used for glide ride assembly BOLT1/4,34 Parts used for slide assembly Main frame layout Step Step Step N10 SecureusingN6 and N9. Seediagram for sequence Attach M4 to L3 Secure using N1,N10 and N8 Z1 Z4 Secure using Z2, Z6, Z7, and Z5 as shown Optional Anchors Frame LEG Manufacturers Limited Warranty