The CEH Industrial Unit Heater
OWNER’S GUIDE
Tools Required: |
|
Appropriate Fasteners | Straight Screwdriver |
Crescent Wrench | Strain Relief Connector |
Phillips Screwdriver | Wire Strippers |
Features & Benefits
•Commercial grade high temperature manual reset
•High mass, tubular element for longer life
•Fan delay eliminates cold draft on startup and disperses residual heat on shutdown
•Rugged die formed construction for durability
•Wire single or three phase to suit the application
•Vertical or horizontal delivery
•5 Year Warranty
Models: |
|
|
| ||
|
|
|
|
| |
|
|
|
• Recommended for elevations under 7500 feet
IMPORTANT INSTRUCTIONS
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock ortagthepanelboarddoortopreventsomeonefrom turning on power while you are working on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
1.Read all instructions before using this heater.
2.Read all information labels. Verify that the electrical supply wires are the same voltage as the heater.
3.All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes.
4.If you need to install a new circuit or need additional wiring information, consult a qualified electrician.
5.Protect electrical supply from kinks, sharp objects, oil, grease, hot surfaces or chemicals.
6.Do not install heater below an electrical convenience receptacle.
7. 
WARNING
Overheating or fire may occur. DO NOT place the heater behind doors.
8. 
WARNING
Fire or explosion may occur. DO NOT place heater in any area where combustible vapors, gases, liquids, or excessive lint or dust are present.
9. 
WARNING 
Burn Hazard. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use extreme caution when any heater is used by or near children or invalids.
10. 
WARNING 
Risk of Electrical Shock. Connect grounding lead to ground- ing terminal provided. Keep all foreign objects out of heater.
11. 
WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of all obstructions: maintain a 3 feet minimum clearance in front, 12 inches on each side, and 6 inches from the rear. Heater must be kept clean of lint, dirt and debris (See Maintenance Instructions)
SAVE THESE INSTRUCTIONS
TEL: