Savannah Rectangle Gazebo Assembly
Step 4: Roof Installation
It is strongly recommended that you use a ladder for the final steps of the gazebo assembly.
When installing the
1.Begin by placing one roof panel on to the roof section and secure using drywall screws (Figure A). Repeat this step until all of the roof panels are secured.
2.Once the roof panels are secured, roll out the felt paper along the bottom of the roof panels (Figure B). Make sure that each layer of felt paper overlaps the previous layer.
3.To help reinforce the gable ends, attach a corbel to each side, on the gable seam. Secure with drywall screws (Figure B).
4. Place each roof tile panel on top of the roof. Do not secure yet. Line up tile panels and make sure that everything is flush, all the way around (Figure B) and that all the channels fit together.
5. Please use the following methods to secure the tile panels (Figure C):
a. Use 1 1/2” screws around the outside portion of the roof
b. Use 3/4” screws staggered all across the roof panels, in the valleys.
6. Attach the roof trim on each end of the roof using drywall screws (Figure C).
7. Place the ridgecap on top of the roof assembly and attach using drywall screws (Figure C).
Page 10 | 2007 Woodcrest Series Gazebo Owner’s Manual |
LTR20071040, Rev. A