Cal Flame Woodcrest Series manual Composition Roof Assembly

Savannah Octagon Gazebo Assembly

Step 2: Composition Roof Assembly

Check the parts list that came with your gazebo and make sure that all the parts are present. Also, please follow the written steps in conjunction with the figures that are shown.

1.Lay the 8-sided main roof support section flat on the ground. Referring the Figure A, attach the roof support boards to the 8-sided main roof support.

2.With the assistance of another person, place the roof frame assembly onto the assembled wall panels. There is a notch at each corner of the wall panel assembly (8 total). Place the roof frame in these notches and secure with drywall screws (Figure A).

3.Place the 4-sided roof tiles (8 total) in the corresponding positions on the roof frame (narrow end on top, wide end on the bottom). Make sure each roof tile is centered on each support before securing. Secure using drywall screws (Figure B). Repeat this step until the roof frame is completely covered.

4.Attach each ridgecap with drywall screws (Figure B). Repeat this step until each roof joint is covered with a ridgecap.

5.With the aid of a ladder, place the copula on top of the finished gazebo. Using the drywall screws, attach the copula to the roof frame (Figure C).

2007 Woodcrest Series Gazebo Owner’s Manual Page 5

LTR20071040, Rev. A