Cal Flame Woodcrest Series manual Wall Panel Assembly

Savannah Octagon Gazebo Assembly

Step 1: Wall Panel Assembly

The assembly instructions contained in this manual are for the Savannah Octagon Gazebo that measures 18’x18’. The assembly instructions will be the same for the 10’x10’, 12’x12’ and 14’x14’ models. The only difference in the assembly of these three models is the amount of steps the owner must perform. Follow the written steps in conjunction with the figures that are shown.

All wall panels are pre-assembled at the factory before being shipped. The smooth side of each wall panel should be facing the inside of the gazebo. Check the parts list that came with your gazebo and make sure that all the parts are present.

1.Stand panels up vertically with the flush side of the panel facing inward (fit panels together as shown in Figure A.

2.Drill holes in all 2”x4” boards. The holes have already been drilled for the wall panels. Line up the holes and mark the 2”x4” and drill accordingly.

3.Insert the provided drywall screws into the pre- drilled holes and tighten with a phillips-head screwdriver (Figure B).

4.Repeat this step until wall panel assembly is complete (Figure C).

5.Using drywall screws to attach the corbels, as shown in Figure C.

Page 4 2007 Woodcrest Series Gazebo Owner’s Manual

LTR20071040, Rev. A