Bush Hog GT 48 manual Electric Start Connection to Engine, Wiring Diagram

White	Red (To Starter)
								To Battery
	Figure 4-2 Wiring Diagram
								- +
						White
Green
		Red	White						Red
							Battery Pigtail
	Green			Red
					To Key Switch
		Orange

4-2 ELECTRIC START CONNECTION TO ENGINE

NOTE

To mount control on ATV, see paragraph 2-4.

A. Cut ring connector from engine end of green wire in cutter wiring harness. (Figure 4-2) Strip 1/4” of insulation from end of green wire.

B. Using butt splice, connect green wire from wiring harness to green wire lead next to engine throttle, crimping with pliers. (Figure 4-3)

C. Attach white wire with loop connector as shown in Figure 4-3.

D. Attach red wire with loop connector and short red jumper wire to post on engine starter solenoid. Attach opposite end of jumper wire to male prong on solenoid.

To Safety

Kill Switch

E. Attach female terminals on end of jumper wires to key switch mounted in control box. Attach female terminal ends on green and orange wires to kill switch mounted in control box. (Figure 4-2)

F. Push engine throttle down to limit of travel. Push remote throttle control to stop position. Insert cable into throttle. Place cable housing under cable clamp and tighten. (Figure 4-3)

G. Plug battery pigtail into harness.

H. Using wire ties, strap throttle control cable and wiring harness together.

Figure 4-3 Honda Engine

White Wire

Butt Splice

Green Wire

Red Wire Red Jumper Wire

16