Bush Hog 280 manual Front Belting Installation, Rear Band Installation, Front Chain Installation

Page 19

5-5 FRONT BELTING INSTALLATION

A. Align belting and clamp with holes in front lip of deck.

B. Fasten with 3/8 x 3-1/2” capscrews, flatwash- ers, lockwashers and nuts. (Figure 5-4)

5-6 REAR BAND INSTALLATION

A. Align deflector band with holes in rear band of deck.

B. Fasten with 3/8 x 1” capscrews, flatwashers, lockwashers and nuts. (Figure 5-4)

5-7 FRONT CHAIN INSTALLATION

A. Align front chain assembly bracket with holes in front lip of deck.

B. Fasten with 3/8 x 3” capscrews, flatwashers, lockwashers and nuts. (Figure 5-5)

5-8 REAR CHAIN INSTALLATION

A. Align rear chain assembly bracket with holes in rear band of deck.

B. Fasten with 3/8 x 1-1/4” capscrews, flatwash- ers, lockwashers and nuts. (Figure 5-5)

CAUTION

USE ONLY FACTORY APPROVED CHAIN GUARDS.

WARNING

FOR NON-AGRICULTURAL USE, OSHA, ASAE, SAE AND ANSI STANDARDS REQUIRE THE USE OF CHAIN GUARDS OR OTHER PROTECTIVE GUARDS AT ALL TIMES. BUSH HOG STRONGLY RECOM- MENDS THE USE OF SUCH GUARDS FOR AGRICULTURAL USES AS WELL, TO REDUCE THE RISK OF PROPERTY DAM- AGE, SERIOUS BODILY INJURY, OR EVEN DEATH FROM OBJECTS THROWN OUT OR FROM CONTACT WITH THE CUTTING BLADES.

Figure 5-6 Clutch Shield

Shield Mount

Rear Band

Figure 5-4

Belting Clamp

Front Belting

Rear Mount Bracket Retaining

Rod

Figure 5-5

Chains

Front Mount

 

Bracket

Retaining Rod

 

Chains

Gearbox

Capscrew, (2) Flatwashers and Locknut

Locknut should be tightened enough to prevent rattling, but loose enough to allow raising the shield.

Patched Capscrew and Flatwasher

18

Image 19
Contents Bush HOG Congratulations Retail CUSTOMER’S Responsibility Under the Bush HOG Warranty Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplySeries Rotary Cutters Dealer Preparation Check ListImportant Safety Precautions Employee Tractor Operating Instructions EMPLOYERS, Employees and OperationsIntroduction Section Introduction and DescriptionDescription Attaching to Tractor Section Preparation for USEPage Section Operating Instructions General SafetyAdjusting for Work Cutting Height AdjustmentMaintenance Check List Section MaintenanceTransporting Slip Clutch Operational Check Blade Holder ASSEMBLY, Removal and InstallationProblem Probable Cause Remedy Slip Clutch AdjustmentPRE-ASSEMBLY Safety Precautions 3-POINT Lift Models 285 Section V AssemblyFront View of Model 287 Lower Hitch Points 3-POINT Lift ModelsQuick Hitch Model SEMI-MOUNT ModelRear Chain Installation Front Belting InstallationRear Band Installation Front Chain InstallationSafety Decals American Torque SpecificationsModel 287 Quick Hitch Assembly Bush HOG