Bush Hog 280 manual Dealer Preparation Check List, Series Rotary Cutters

Page 5

DEALER PREPARATION CHECK LIST

280 SERIES ROTARY CUTTERS

BEFORE DELIVERING MACHINE — The following check list should be completed. Use the Operator’s Manual as a guide.

❒1. Assembled completed.

❒2. Gearbox filled with oil.

❒3. All fittings lubricated.

❒4. All shields in place and in good condition.

❒5. All fasteners torqued to specifications given in Torque Chart.

❒6. Slip clutches have been checked for proper operation.

❒7. All decals in place and readable. (See decal page.)

❒8. Overall condition good (i.e. paint, welds)

❒9. Operators manual has been delivered to owner and he has been instructed on the safe and proper use of the cutter.

❒10. Purchaser or dealer elects to delete deflectors. (front belting, rear bands, front

and rear chains)

Explanation:

WARNING

For Non-Agricultural use, OSHA, ASAE, SAE and ANSI standards require the use of Chain Guards or other protective guards at all times. Bush Hog strongly recommends the use of such guards for Agricultural uses as well, to reduce the risk of property damage, serious bodily injury or even death from objects thrown out by or from con- tact with the cutting blades.

Dealer’s

Signature

Purchaser’s

Signature

THIS CHECKLIST TO REMAIN IN OWNER’S MANUAL

It is the responsibility of the dealer to complete the procedures listed

above before delivery of this implement to the customer.

4

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Bush HOG Congratulations Retail CUSTOMER’S Responsibility Under the Bush HOG Warranty Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplySeries Rotary Cutters Dealer Preparation Check ListImportant Safety Precautions Employee Tractor Operating Instructions EMPLOYERS, Employees and OperationsDescription Section Introduction and DescriptionIntroduction Attaching to Tractor Section Preparation for USEPage Adjusting for Work General SafetyCutting Height Adjustment Section Operating InstructionsTransporting Section MaintenanceMaintenance Check List Slip Clutch Operational Check Blade Holder ASSEMBLY, Removal and InstallationProblem Probable Cause Remedy Slip Clutch AdjustmentPRE-ASSEMBLY Safety Precautions 3-POINT Lift Models 285 Section V AssemblyFront View of Model 287 Lower Hitch Points 3-POINT Lift ModelsQuick Hitch Model SEMI-MOUNT ModelRear Band Installation Front Belting InstallationFront Chain Installation Rear Chain InstallationSafety Decals American Torque SpecificationsModel 287 Quick Hitch Assembly Bush HOG
Top Page Image Contents