Brinkmann Sl 7 owner manual Changing Bulb, Changing Batteries

Bulb

Lens

Rear Housing

Battery

Tape

Front Housing

IMPORTANT: The sealed battery in this product contains lead and must be recycled or disposed of properly. For additional infor- mation regarding disposal, contact your local county solid waste authority.

Changing Bulb

1.Turn lens counterclockwise and remove.

2.Pull bulb straight out and replace with new bulb. DO NOT PLACE NEW BULB IN BRASS GROMMET HOLES.

3.Replace the lens by aligning the slots with the grooves in the top housing and turning clock- wise to lock in place.

Changing Batteries

1.Unscrew the four screws in front housing and separate it from rear housing.

2.Carefully peel the tape off the battery, leaving wires attached to tape.

3.Remove the battery from rear housing, being careful not to pull on wires.

4.Disconnect wires from battery terminals and remove battery.

5.Connect wires to new battery terminals. Make sure red (+) wire is connected to red (+) terminal and black (-) wire is con- nected to black (-) terminal.

Terminal

Wire Connector

6.Place new battery in rear housing.

7.Attach tape and wires to front of battery.

8.Attach the front housing to rear housing using the four screws that were removed in Step 1.

9.Place switch in the “OFF” position and charge in full, direct sunlight for THREE FULL DAYS. Then slide the switch to the “AUTO” position. The light will turn on automatically at night when it detects motion.

6