Brinkmann Sl 7 owner manual Cleaning Storage Wintertime Tips, Solar Panel Module Cord

Page 8

Cleaning

Storage

Wintertime

Tips

Troubleshooting & Important Information

Solar Panel

Module Cord

It is important that the solar panel is kept free of dirt and debris. A dirty solar panel will not allow the battery to fully charge. This will shorten the life of the battery and cause the light to malfunction. Clean regularly with a dampened cloth or paper towel.

Solar security lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to battery:

1.Turn the switch to “OFF” position. Store at room temperature in a dry area.

2.Never store unit with switch in “AUTO” or “TEST” position. This will damage the battery and it will not recharge.

3.Store light and solar panel where it can receive some sunlight or room light each day. The battery needs light to maintain a charge dur- ing storage.

4.During prolonged storage, unit must be fully charged once every four months. You may need to replace the battery after prolonged storage.

5.Never store the unit in a box or in a dark room without a source of light on the solar panel or you may need to replace the battery before next use.

6.For best performance, do not store for prolonged periods.

1.Clean snow and debris off the solar panel so the battery can recharge.

2.Check and replace battery periodically throughout the year, especially after winter months.

If lights blink on and off:

Direct lamps away from detector or reposition detector.

Remove heat sources located near or under detector.

Direct detector away from streets or active sidewalks.

If lights do not turn on at night:

Switch is in the “OFF” Position. When the switch is in the “OFF” posi- tion, light will not turn on after dark. Move switch to the “AUTO” posi- tion and check for normal operation after dark.

Make sure the solar panel module cord is plugged firmly into main housing. The battery will not charge if this connection is loose.

Battery is not fully charged or needs replacement:

a.Make sure light is located in an area where the solar panel gets the maximum amount of full, direct sunlight every day.

7

Image 8
Contents Assembly and Operating Instructions Important Before First USE Solar Panel Detection ZoneAssembly Instructions Home Security Main HousingMain Housing Mounting Screws Solar Panel Module with CordStep Motion Detector Head Feet Testing Instructions Bulb Lens Rear Housing Battery Tape Front Housing Disconnect wires from battery terminals and remove batteryChanging Bulb Changing BatteriesCleaning Storage Wintertime Tips Battery is not fully charged or needs replacementSolar Panel Module Cord If lights blink on and offIf range is too short or too long Troubleshooting & Important Information con- tinuedIf lights come on randomly Screw Hole TemplateCut along dotted line 140-6007-0 Home Security Accessories ONE Year Limited Warranty