|
| 500Z 26HP - 48” Mower Deck |
| Uncrating |
|
1. | Using a reciprocating utility saw or equivalent, cut the |
|
| crate away from the bottom skid. Remove the crate. |
|
| Remove the |
|
2. | Cut the nylon banding from the front of the frame and |
|
| the rear of the bumper. |
|
| IMPORTANT NOTE |
|
| When cutting the crate from the bottom | A |
| skid, use caution around tractor tires |
|
| and mower rollers. | C |
| B | |
3. | Pull both transmission release levers (A, Figure 1) |
|
| back and then down to lock the transmission release |
|
| levers in the disengaged |
|
4. | Push down on the parking brake lever to release the |
|
| parking brake. |
|
5. Be sure there are no nails or sharp objects on the | Figure 1. Transmission Release Levers (LH shown) |
A. Transmission Release Lever | |
bottom skid to puncture the tractor’s tires. Roll the | B. Engaged Position (Drive Position) |
tractor forward off the bottom skid. | C. Disengaged Position |
6.After moving the tractor,
Battery Installation
WARNING
BATTERY SAFETY RULES
•Battery acid causes severe burns. Avoid contact with skin.
•Wear eye protection while handling the battery.
•To avoid an explosion, keep flames and sparks away from the battery, especially while charging.
•When installing the battery cables, CONNECT THE POSITIVE (+) CABLE FIRST and the negative
Connect Battery
1.Connect the red positive battery cable (A, Figure 2) to the positive battery post. Make sure that the cable boot completely covers the positive terminal, so the terminal cannot touch the insulator pad (C).
2.Connect the black negative battery cable (B) to the negative battery post.
C |
A |
B |
Figure 2. Connect the Battery
A.Positive (+) Cable, Terminal & Boot
B.Negative (-) Cable & Terminal
C.Insulator Pad
1/2008 | 3 | TP |