Briggs & Stratton 500Z - 26 manual Check Deck Rod Timing, Check Lift Rod Timing

Page 7

 

500Z 26HP - 48” Mower Deck

Check Deck Rod Timing

 

1. Park machine on a flat, level surface. Disengage the

 

PTO, stop the engine and engage the parking brake.

 

Rear tires must be inflated to 15 psi (1,03 bar); front

 

tires to 40 psi (2,76 bar).

 

2. To check the lift rod timing, measure and record the

 

distance between the lift pivots and the rod pivots.

 

Repeat for the other side of the machine. See Figure

 

8.

Figure 8. Check Lift Rod Timing

 

3.If the measurements for the rods are equal, no further adjustment is required. If the measurements

are NOT equal (greater than 1/8” (3,17mm) difference), adjustment is required, continue with Step 5.

4. Lock the deck lift pedal in the 4-1/2” (11,47cm) position. Remove the cutting height adjustment pin and lower the mower deck.

5.To ensure that the deck is in the lowest position, push the pedal by hand towards the rear of the

machine and install the height adjustment pin in the 3” (7.6cm) position to hold in place.

6. Block up the mower deck until all hanger chains are

Figure 9. Adjust Lift Rod Timing

slack.

 

7.See Figure 9. To adjust the lift rod, loosen the jam nut on the clevis then remove the 1/2” clevis pin fastening the clevis the the lift pivot arm. Turn the clevis clockwise to shorten the distance between the rod pivots or counterclockwise to lengthen the distance between the rod pivots. Reinstall the clevis on the lift pivot arm and secure with the 1/2” clevis pin previously removed. Tighten the jam nut against the clevis.

8.Remove the blocks from under the mower deck.

9.Remove the the cutting height adjustment pin from in front of the deck lift pedal arm. Lift the mower deck and reinstall the adjustment pin in the desired mowing height.

1/2008

7

TP 300-7368-IR-ZT-N

Image 7
Contents Dealer Setup Adjustment Instructions 500Z 26HP 48 Mower Deck Quick Setup ListBe sure there are no nails or sharp objects on Battery InstallationConnect Battery UncratingInstall Ground Speed Control Levers Tractor AssemblySeat Assembly Check / Fill Transmission Oil Check Fluid LevelsCheck Tire Pressures Check the Engine Oil LevelCheck Torque Mower Blades Check the Mower AssemblyCheck Lift Rod Timing Check Deck Rod Timing4 Locations Deck Leveling AdjustmentModels Check Deck Drive BeltLubricating the Front Casters LubricationGrease OilAdding Fuel Adding FuelStarting The Engine To add fuelFunctional Tests Perform Safety ChecksSeat Adjustment Lever Seat AdjustmentGround Speed Control Adjustment Seat AdjustmentReturn-to-Neutral Adjustment Jam Nuts Neutral Return Rod Return-To-Neutral AdjustmentParking Brake Adjustment 500Z 26HP 48 Mower Deck