Operating the Mower
TO ADJUST CUTTING HEIGHT
The front skids on the brush cutter have 3 sets of holes (Figure 9) for height adjustment:
–Top holes - 3 1/4" cutting depth
–Center holes - 4" cutting depth
–Bottom holes - 4 3/4" cutting depth
• Shut off engine.
• Loosen bolts holding skids.
• Move skid to desired location.
• Reinstall bolts.
STORAGE
WARNING
Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also toxic to humans and animals.
Before you store your unit for the
•Disengage the PTO and remove the key.
•Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed struc- ture - see above).
B
C
C
D
A
Figure 9 - Adjusting Height
A.Skid
B.Capscrew
C.Washer
D.Nut
•Battery life will be increased if it is removed, put in a cool, dry place and fully charged about once a month. If the battery is left in the unit, disconnect the nega- tive cable.
Before starting the unit after it has been stored:
•Check all fluid levels. Check all maintenance items.
•Perform all recommended engine checks and proce- dures found in the engine owner's manual.
•Allow the engine to warm up for several minutes before using mower.
10