Mower Cutting Height Switch
To increase the mower cutting height (raise the mower deck), press the top of the yellow cutting height switch. To decrease mower cutting height (lower the mower deck), press the bottom of the switch. Mower cutting height range is approximately
Ignition Switch
The ignition switch starts and stops the engine; it has three positions:
OFF Stops the engine and shuts off the electrical system.
RUN Allows the engine to run and powers the electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN position with the engine stopped. This drains the battery.
Hour Meter
The hour meter measures the number of hours the key has been in the RUN position.
NOTE: The hour meter will register the passage of time when the key is in the RUN position, even if the engine is not running.
Mower Blade Switch
The yellow mower blade switch turns the mower blades on and off. To turn the mower blades ON, pull the switch up. To turn the mower blades OFF, push the switch down. Always set the engine speed control to FAST before turning the mower blades ON, and while mowing.
Transmission Release Levers
The transmission release levers deactivate the transmissions so that the unit can be pushed by hand. See PUSHING THE UNIT BY HAND for operational information.
Fuel Tank
To remove the fuel tank cap, turn it counterclockwise.
GENERAL OPERATING SAFETY
Before first time operation:
•Be sure to read all information in the Safety and Operation sections before attempting to operate this rider and mower.
•Become familiar with all of the controls and how to stop the unit.
•Drive in an open area without mowing to become accustomed to driving the unit.
WARNING
If you do not understand how a specific control functions, or have not yet thoroughly read the CONTROL FUNCTIONS section, do so now.
Do NOT attempt to operate the rider without first becoming familiar with the location and function of ALL controls.
10