Briggs & Stratton 150Z Series manual Mower Deck Removal Installation, Removing the Mower Deck

Page 17

MOWER DECK REMOVAL &

INSTALLATION

NOTE: Perform mower removal and installation on a hard, level surface such as a concrete floor.

WARNING

After lowering the mower cutting height, engage parking brake, turn off the mower blades, turn the ignition switch to STOP, and remove key before attempting to install or remove the mower.

Removing the Mower Deck

1.Turn the mower blades OFF, put the ground speed control levers in START/PARK position, turn the ignition OFF, and wait for all moving parts to stop.

2.Pivot the front wheels forward.

3.Use the mower belt release lever (D, Figure 11) to release belt tension. Remove the mower belt from engine pulley (A).

4.Turn the ignition switch from OFF to RUN without starting the engine.

5.Use the mower cutting height switch to raise the mower deck.

6.Place 4x4 wood blocks (D, Figure 10) under the front and rear lip of the mower deck to securely support it.

7.Use the mower cutting height switch to fully lower the mower so that is it resting on the 4x4 wood blocks.

8.Turn the ignition switch to OFF and remove the key.

9.Remove the hair pin clip (A) securing the rear mower lift arm. Separate the lift arm from the mower deck. Repeat on both sides of the mower.

10.Remove the hitch rod (C) from the hitch bracket.

11.Slide the mower deck out from under the rider.

Installing the Mower Deck

1.Slide the mower deck under the right side of the rider. Slide the mower forward and hook the front hitch rod (C, Figure 10) to the front mower deck hooks.

2.Slide the mower deck backwards and connect the rear lift arms to the mower deck. Secure with hair pin clips (A).

3.Insert the key into the ignition switch. Turn the switch from OFF to RUN without starting the engine.

4.Use the cutting height switch to raise the mower until it is no longer resting on the 4x4 wood blocks (D).

5.Turn the ignition switch OFF and remove the key. Remove the 4x4 blocks (D).

6.Use the mower belt release lever to release mower belt tension, and install the belt as shown in Figure 11.

B C

A

D

Figure 10. Mower Hitch Components

A.Hair Pin Clip

B.3/8-16 x 3/4 Carriage Bolt & Flange Nut

C.Hitch Rod

D.4x4 Wood Blocks

 

B

C

A

 

 

C

E

D

E

Figure 11. Mower Belt Routing

A.Engine Pulley

B.Mower Drive Belt

C.Back-Side Idler Pulleys

D.Mower Belt Release Lever

E.Arbor Pulleys

15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 20HP Zero-Turn Riders OPERATOR’S ManualPage Table of Contents General Operation Safety RulesIgnition System Only Ride UP and Down Hill Not Across Hill Degrees MAX Safe Handling of Gasoline Service & Maintenance2690716 Safety & Operation DecalsMfg. No ID Tag Identification NumbersControl Functions OperationGround Speed Levers Parking Brake Engine Speed ControlGeneral Operating Safety Fuel Recommendations Checks Before StartingStopping the Rider & Engine Emergency StoppingStarting the Engine MowingSmooth Travel Driving PracticeForward Travel Practice Reverse Travel PracticePractice Turning In Place Practice Turning Around a CornerExecuting Turns Executing an End-Of-Row Zero TurnRemoving the Mower Deck Mower Deck Removal InstallationInstalling the Mower Deck Maintenance Schedule MaintenanceRider MAINTENANCE, All Models 20HP Briggs & StrattonClean Debris from Rider Engine Compartment Accessing the Engine CompartmentClean Debris from Engine Cooling Areas and AIR Filter Check Tire PressureOil LubricationGrease Blade Removal Clean Deck Check / Replace Mower BladesOperational Safety Checks Clean the Battery and CablesCheck Rider Safety System Adjust PTO Clutch Window Adjustment Nut Feeler Gauge Check / Adjust PTO ClutchChange Engine OIL & Filter Check Engine OIL LevelChange Engine OIL Air Filter Removal & Installation Service AIR Filter PRE-CLEANERReplace Spark Plug Pre-Cleaner ServiceAir Filter Service Pre-Cleaner Ground Speed Control Lever Adjustment Service & AdjustmentsSpeed Balancing Adjustment Cutting Height AdjustmentBattery Charging Brake AdjustmentEngine Adjustments 62cmSide to Side Leveling Mower Deck Leveling AdjustmentsFront To Back Leveling Mower Belt ReplacementMower Drive Belt Replacement Storage StorageBefore Storage After StorageTroubleshooting the Rider TroubleshootingTroubleshooting the Mower Service Items SpecificationsEngine Transmission ChassisPage WATER, Fertilize HOW and When toAerate HOW High to MOW the GrassProper Mowing Speed When and HOW Often to MOW
Top Page Image Contents