Bolens Series 540 manual Storing your Lawn Mower

Page 13

Remove the blade and the adapter from the crankshaft.

Blade

Adapter

Blade Bell

Support

Hex Bolt

Figure 14

WARNING: Periodically inspect the blade adapter for cracks, especially if you strike a foreign object. Replace when necessary.

When sharpening the blade, follow the original angle of grind as a guide. It is extremely important that each cutting edge receives an equal amount of grinding to prevent an unbalanced blade. An unbalanced blade will cause excessive vibration when rotating at high speeds. It may cause damage to the mower, and could break causing personal injury.

The blade can be tested by balancing it on a round shaft screwdriver. Remove metal from the heavy side until it balances evenly. It is recommended that the blade always be removed from the adapter when testing for balance. Before reinstalling the blade and the blade adapter to the unit, lubricate the engine crankshaft and the inner surface of the blade adapter with light oil.

Be sure to install the blade with the side of the blade marked “Bottom” (or with part number) facing the ground when the mower is in the operating position.

Slide the blade adapter onto the engine crankshaft.

Place the blade on the adapter. Be certain the blade is aligned and seated on the blade adapter flanges.

Place blade bell support on blade. Make sure the notches on the blade bell support are aligned with small holes in the blade.

Replace hex bolt and tighten hex bolt to torque: 450 in. lbs. min., 600 in. lbs. max.

NOTE: To ensure safe operation of your mower, the blade bolt must be checked periodically for correct torque.

Storing your Lawn Mower

The following steps should be taken to prepare your lawn mower for storage.

Clean and lubricate mower thoroughly as described in the lubrication instructions.

IMPORTANT:We do not recommend the use of a pressure washer or garden hose to clean your unit.

Refer to engine manual for correct engine storage instructions.

Coat mower’s cutting blade with chassis grease to prevent rusting.

Store mower in a dry, clean area. Do not store next to corrosive materials, such as fertilizer.

NOTE: When storing any type of power equipment in a poorly ventilated or metal storage shed, care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all moving parts.

13

Image 13
Contents OPERATOR’S Manual Table of Contents General Operation Important Safe Operation PracticesSlope Operation ServiceChildren Page Slope Gauge Setting Up Your Lawn Mower Disconnecting Spark Plug WireAssembling Your Lawn Mower Removing Unit From CartonAttaching Starter Rope Converting To Side DischargeOperating Your Lawn Mower Know Your Lawn MowerGas and Oil Fill-Up Starting EngineHandle Height Adjustment Using Your Lawn MowerCutting Height Adjustment MulchingMaintaining Your Lawn Mower Engine AdjustmentsGeneral Recommendations Cutting Blade Removal, Replacement, and Sharpening Maintenance Replacing Rear FlapLubrication EngineStoring your Lawn Mower Problem Cause Remedy TroubleshootingPage Model Series Part Description Model SeriesPage Page MANUFACTURER’S Limited Warranty for