IGNITION SWITCH
To start the engine, insert key into the ignition switch and turn clockwise to the START position. Release key to the ON position once engine has fired. See Figure 4. Refer to STARTING THE ENGINE in the OPERATION section of this manual for detailed starting instructions. The ignition switch is also used to operate the headlights. Refer to OPERATING THE HEADLIGHTS in the OPERATION section of this manual for detailed instructions
WARNING: Remove the key from the tractor when the tractor is not in use to prevent accidental starting.
Off
On/Lights
On
Start
Figure 4
THROTTLE CONTROL LEVER
The throttle lever is located on the right side of the tractor’s dash panel. This lever controls the speed of the engine, and on some units the choke control also. When set in a given position, the throttle will maintain a uniform engine speed. See Figure 5.
Throttle |
| Throttle | ||||||
Symbol |
|
|
|
| Symbol |
| ||
Choke |
| Fast |
| |||||
|
|
|
|
|
| |||
Position |
| |||||||
| Position | |||||||
|
|
|
|
|
| |||
Fast |
|
|
|
| ||||
Position |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Slow |
| Slow |
|
Position |
| Position | |
Figure 5
IMPORTANT: When using PTO operated equipment such as the cutting deck or other attachments, ALWAYS operate the tractor with the throttle lever in the FAST (rabbit) position.
CHOKE CONTROL
On some units, moving the throttle lever all the way forward activates the engine’s choke control. On all other units, the choke control can be found on the left side of the dash panel and is activated by
pulling the knob outward. Activating the choke control closes the choke plate on the carburetor and aids in starting the engine. Refer to STARTING THE ENGINE in the OPERATION section of this manual for detailed starting instructions.
SYSTEMS INDICATOR MONITOR
Your tractor is equipped with an ammeter as part of its systems indicator monitor and is located on the left side of your tractor’s dash panel. See Figure 6.
Oil
AMPS
Brake
Ammeter
PTO
Figure 6
If the Brake light or PTO light illuminates when attempting to start the unit, proceed as follows:
Depress the brake pedal.
Move PTO lever into the disengaged (OFF) position.
It is normal for the Oil light to illuminate while the engine is cranking, but if it illuminates while the engine is running, proceed as follows:
Stop the tractor immediately and check the crankcase oil level as instructed in the seperate engine manual packed with your unit. Add oil as required.
The ammeter measures the the electrical output of the engine’s charging system. Under normal operating conditions, with the engine running at full throttle, the ammeter’s needle should measure a positive charge.
9