•Disengage all attachment clutches, thoroughly depress the brake pedal, and shift into neutral before attempting to start engine.
•Your mower is designed to cut normal residential grass of a height no more than 10". Do not attempt to mow through unusually tall, dry grass (e.g., pasture) or piles of dry leaves. Debris may build up on the mower deck or contact the engine exhaust presenting a potential fire hazard.
2.SLOPE OPERATION
Slopes are a major factor related to loss of control and tip- over accidents which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.
For your safety, use the slope gauge included as part of this manual to measure slopes before operating this unit on a sloped or hilly area. If the slope is greater than 15° as shown on the slope gauge, do not operate this unit on that area or serious injury could result.
DO:
•Mow up and down slopes, not across.
•Remove obstacles such as rocks, limbs, etc.
•Watch for holes, ruts or bumps. Uneven terrain could overturn the machine. Tall grass can hide obstacles.
•Use slow speed. Always keep machine in gear when going down slopes to take advantage of engine braking action.
•Follow the manufacturer’s recommendations for wheel weights or counterweights to improve stability.
•Use extra care with grass catchers or other attachments. These can change the stability of the machine.
•Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Rapid engagement or braking could cause the front of the machine to lift and rapidly flip over backwards which could cause serious injury.
•Avoid starting or stopping on a slope. If tires lose traction, disengage the blade(s) and proceed slowly straight down the slope.
DO NOT:
•Do not turn on slopes unless necessary; then, turn slowly and gradually downhill, if possible.
•Do not mow near
•Do not mow on wet grass. Reduced traction could cause sliding.
•Do not try to stabilize the machine by putting your foot on the ground.
•Do not use grass catcher on steep slopes.
3. CHILDREN
Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that chil- dren will remain where you last saw them.
•Keep children out of the mowing area and in watchful care of an adult other than the operator.
•Be alert and turn machine off if children enter the area.
•Before and when backing, look behind and down for small children.
•Never carry children, even with the blades off. They may fall off and be seriously injured or interfere with the safe machine operation.
•Never allow children under 14 years old to operate the machine. Children 14 years and over should only operate machine under close parental supervision and proper instruction.
•Remove key when machine is unattended to prevent unauthorized operation.
•Use extra care when approaching blind corners, shrubs, trees or other objects that may obscure your vision of a child or other hazard.
4.SERVICE
•Use extreme care in handling gasoline and other fuels. They are extremely flammable and the vapors are explosive.
•Use only an approved container.
•Never remove fuel cap or add fuel with the engine running. Allow engine to cool at least two minutes before refueling.
•Replace fuel cap securely and wipe off any spilled fuel before starting the engine as it may cause a fire or explosion.
•Extinguish all cigarettes, cigars, pipes and other sources of ignition.
•Never refuel the machine indoors because fuel vapors will accumulate in the area.
•Never store the fuel container or machine inside where there is an open flame or spark, such as a gas hot water heater, space heater or furnace.
•Never run a machine inside a closed area.
•To reduce fire hazard, keep the machine free of grass, leaves or other debris
•Before cleaning, repairing or inspecting, make certain the blade and all moving parts have stopped. Disconnect the spark plug wire, and keep the wire away from the spark plug to prevent accidental starting.
•Check the blade and engine mounting bolts at frequent intervals for proper tightness. Also, visually inspect blade for damage (e.g., excessive wear, bent, cracked). Replace with blade which meets original equipment specifications.
4