Bolens 5264D manual Adjusting the Seat Belt, Three Point Hitch Adjustments

Page 22

SECTION 3: ADJUSTMENTS

ADJUSTING THE SEAT

For the comfort of the operator, a single lever adjustable seat is provided to set the fore to aft position of the seat. Adjust the seat to the most comfortable position that allows you to operate all controls and pedals.

WARNING: Do not adjust the seat when the tractor is moving, as this could cause the operator to lose momentary control of the tractor and result in an accident.

•To adjust the seat, pivot the seat adjustment lever to the left and hold while repositioning the seat to the desired position.

•After repositioning the seat, release the lever to lock the seat in position. Slide the seat either slightly forward or rearward to assure it is locked, or until engagement of the lock is felt. See Figure 24.

SEAT

ADJUSTMENT

LEVER

Pivot Lever to Left

Figure 24

ADJUSTING THE SEAT BELT

WARNING: Always wear the seat belt when operating the tractor equipped with a ROPS. If the ROPS has been lowered or removed, the seat belt should not be used.

NOTE: If the belt is too long or too short to be prop- erly adjusted using the upper belt webbing, the adjustment clip should be repositioned. To do so, firmly grasp the adjustment clip and pull the lower webbing though the clip. Move the clip toward the anchor point at the seat to shorten the belt, or toward the buckle link the lengthen the belt.

Adjust the final length of the seat belt using the adjuster clip, buckle link, and upper belt webbing on the right half of the belt.

•To lengthen the belt, hold the ends of the adjuster clip and tip upward the side of the clip toward the buckle link. See Figure 25.

•While holding the clip, pull the upper webbing of the belt through the clip toward the buckle link. See Figure 25.

•Hold the belt and pull the buckle link to the left to remove the slack in the upper webbing of the belt between the adjuster clip and the link.

BUCKLE Tip Sides of Clip

RELEASE

BUTTONPull Belt to Pull Belt to

Lengthen Shorten

BUCKLE

 

 

 

 

 

 

 

ADJUSTER

 

 

 

 

 

 

 

CLIP

LINK

 

UPPER

 

 

 

 

 

LOWER

 

 

 

 

WEBBING

 

 

 

WEBBING

Figure 25

•To shorten the belt, tip the other side of the clip upward, pull the free end of the belt webbing to the right, and pull the buckle link to the left to remove the slack.

THREE POINT HITCH ADJUSTMENTS

•Adjust the RH adjustable lift link to level the lower hitch links. Loosen the jam nut and turn the adjustment tube as shown in Figure 26 to shorten or lengthen the lift link. Tighten the jam nut against the adjustment tube after adjusting.

 

JAM

Loosen

NUT

Jam Nut

 

ADJUSTMENT

Shorten TUBE

Lengthen

Figure 26

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Important Read Safety Rules and Instructions Carefully Operator’s ManualCalling Service Information Table of ContentsTo the Owner Recording Model and Serial Number Information Rops Information PlateImportant Safe Operation Practices General OperationSlope Operation Do notChildren Safety Frame RopsService Operating the PTOPage FAN Warning Label Located on Each Side of Radiator Safety LabelsBattery Warning Label Located Under Hood PTO Warning Label Located on Rear PTO ShieldControls and Features Steering Wheel PTO SwitchIgnition Switch Throttle HandleHand Holds Seat Adjustment LeverPTO Reverse Override Switch Transmission 4WD Shift LeverDifferential Lock Pedal Hazard Light SwitchHeadlight Switch Foldable Rops Rollover Protective StructurePTO Engaged Indicator Battery Indicator LightOil Pressure Indicator Brake Engaged IndicatorRollover Protective Structure Rops Safety Interlock SystemOperation Folding the RopsFueling the Tractor NEW Tractor BREAK-IN ProceduresStarting the Engine Stopping the Engine Using Jumper Cables to Start EngineCold Weather Starting below 14 F Driving the TractorLOW Using the Forward and Reverse PedalsUsing the HI/LO Range Shift Lever Stopping the TractorUsing the 4WD Shift Lever Using the Differential Lock PedalDriving on Slopes Engaging the PTO Using the Hydraulic Lift LeverUsing the PTO Reverse Override Switch LightingHazard Lights Using the TOP Link Retainer HookUsing the Three Point Hitch Removing the Rear PTO CoverFront Weights Using the Hitch PlateTractor Weighting Weighting the Rear of the TractorAdjusting the Seat Belt AdjustmentsAdjusting the Seat Three Point Hitch AdjustmentsAdjusting Front Wheel TOE-IN Check the TOE-IN AS FollowsAdjusting the Brakes Lubrication Table MaintenanceGeneral Information Lubrication and Maintenance Chart Illustration Lubrication and Maintenance Chart Service Intervals Operation toAccessing the Engine Compartment General Battery InformationBattery Maintenance Battery RemovalCharging the Battery Battery StorageMain Fuse Azard Bulb ReplacementServicing Electrical System Never use a higher amperage fuseRight Side Accessing the Lower Dash Panel AreaElectrical Circuit Relays Left SideChecking TRANSMISSION/HYDRAULIC System OIL Level Hydraulic System Filter Part NoChanging Hydraulic System Filter Changing the Hydro Transmission and Hydraulic System OILCheck Final Reduction Gear Case Oil Check Front Axle OilChanging Front Axle and Final Reduction Gear Case OIL Lubrication of FWD Drive Shaft Lubrication of Drive ShaftWheel LUG NUT Torque Tire Maintenance Maintenance of the Rollover Protective Structure RopsTractor Storage Removing the Tractor from StorageEngine Information and Maintenance Daihatsu Emission Control Defects Warranty CoverageIgnition System Checking Engine OIL Level Engine Maintenance Cleaning the EngineCleaning the Radiator SCREEN/RADIATOR Adding Engine OILChanging the Engine OIL and Filter Inspection of Cooling System Hoses Checking Engine Coolant LevelChanging the Engine Coolant Changing the AIR Cleaner Draining The Fuel Filter Servicing the Fuel FilterChanging The Fuel Filter Specifications Hydraulic Lift System Power Take-OffGeneral Dimensions BrakesOptional Equipment and Accessories Description Model NumberCUB Cadet LLC Post Office BOX CLEVELAND, Ohio
Top Page Image Contents