Bolens 5264D manual Battery Removal, Charging the Battery, Battery Maintenance, Battery Storage

Page 29

BATTERY REMOVAL

WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. Wash hands after handling.

The battery is located at the front of the tractor beneath the hood.

To remove the battery:

Open the tractor hood as described in the previous sub-section.

Remove the two wing nuts and the battery holddown strap from the battery holddown rods. See Figure 34.

Spread the locking clips on the sides of the terminal covers and lift the tops of the covers to expose the battery connections. See Figure 34.

Loosen the cable clamp of the black negative battery lead, then lift the negative cable and its terminal cover off the negative battery post (marked NEG). Move the cable away from the negative battery post.

Repeat the above procedure to remove the cable and cover from the positive battery post (marked POS).

Carefully lift the battery out of the tractor.

Install the battery by repeating the above steps in the reverse order.

WARNING: Always connect the posi- tive lead to the battery before con- necting the negative lead. This will pre- vent sparking or possible injury from an electrical short caused by contact- ing the tractor body with tools being used to connect the cables.

HOLDDOWN STRAP

 

 

 

 

CABLE

 

 

WING NUT

 

 

 

 

 

 

CLAMP

 

 

 

 

 

 

 

 

 

BATTERY

 

TERMINAL

 

HOLDDOWN

 

 

COVER

ROD

 

 

 

 

Figure 34

CHARGING THE BATTERY

Test and, if necessary, recharge the battery after the tractor has been stored for a period of time.

A voltmeter or load tester should read 12.6 volts (DC) or higher across the battery terminals.

Charge the battery with a 12-volt battery charger at a MAXIMUM rate of 10 amps.

Voltmeter

State of

Charging

Reading

Charge

Time

12.7

100%

Full Charge

12.4

75%

90 Min.

12.2

50%

180 Min.

12.0

25%

280 Min.

 

 

 

BATTERY MAINTENANCE

The battery is filled with battery acid and then sealed at the factory. However, even a “maintenance free” battery requires some maintenance to ensure its proper life cycle.

Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion.

Always keep the battery cables and terminals clean and free of corrosion.

Always keep the terminal covers in place and closed over the battery terminals.

Avoid tipping. Even a sealed battery will leak electrolyte when tipped.

BATTERY STORAGE

When storing the tractor for extended periods, disconnect the negative battery cable. It is not necessary to remove the battery.

All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge more rapidly.

The battery must be stored with a full charge. A discharged battery can freeze sooner than a charged battery. A fully charged battery will store longer in cold temperatures than hot.

Recharge the battery before returning to service. Although the tractor may start, the engine charg- ing system may not fully recharge the battery.

HEAD LIGHT BULB REPLACEMENT

The tractor is equipped with headlights. If one of the bulbs should burn out, replace the bulb as follows:

Fully raise the hood.

Pull the wire harness plug from the bulb/socket assembly to unplug the wire harness. Refer to Figure 35.

29

Image 29
Contents Operator’s Manual Important Read Safety Rules and Instructions CarefullyTo the Owner Table of ContentsCalling Service Information Rops Information Plate Recording Model and Serial Number InformationGeneral Operation Important Safe Operation PracticesDo not Slope OperationService Safety Frame RopsChildren Operating the PTOPage Battery Warning Label Located Under Hood Safety LabelsFAN Warning Label Located on Each Side of Radiator PTO Warning Label Located on Rear PTO ShieldControls and Features Ignition Switch PTO SwitchSteering Wheel Throttle HandlePTO Reverse Override Switch Seat Adjustment LeverHand Holds Transmission 4WD Shift LeverHeadlight Switch Hazard Light SwitchDifferential Lock Pedal Foldable Rops Rollover Protective StructureOil Pressure Indicator Battery Indicator LightPTO Engaged Indicator Brake Engaged IndicatorOperation Safety Interlock SystemRollover Protective Structure Rops Folding the RopsStarting the Engine NEW Tractor BREAK-IN ProceduresFueling the Tractor Cold Weather Starting below 14 F Using Jumper Cables to Start EngineStopping the Engine Driving the TractorUsing the HI/LO Range Shift Lever Using the Forward and Reverse PedalsLOW Stopping the TractorDriving on Slopes Using the Differential Lock PedalUsing the 4WD Shift Lever Using the PTO Reverse Override Switch Using the Hydraulic Lift LeverEngaging the PTO LightingUsing the Three Point Hitch Using the TOP Link Retainer HookHazard Lights Removing the Rear PTO CoverTractor Weighting Using the Hitch PlateFront Weights Weighting the Rear of the TractorAdjusting the Seat AdjustmentsAdjusting the Seat Belt Three Point Hitch AdjustmentsCheck the TOE-IN AS Follows Adjusting Front Wheel TOE-INAdjusting the Brakes General Information MaintenanceLubrication Table Lubrication and Maintenance Chart Illustration Service Intervals Operation to Lubrication and Maintenance ChartGeneral Battery Information Accessing the Engine CompartmentCharging the Battery Battery RemovalBattery Maintenance Battery StorageServicing Electrical System Azard Bulb ReplacementMain Fuse Never use a higher amperage fuseElectrical Circuit Relays Accessing the Lower Dash Panel AreaRight Side Left SideHydraulic System Filter Part No Checking TRANSMISSION/HYDRAULIC System OIL LevelChanging the Hydro Transmission and Hydraulic System OIL Changing Hydraulic System FilterChanging Front Axle and Final Reduction Gear Case OIL Check Front Axle OilCheck Final Reduction Gear Case Oil Wheel LUG NUT Torque Lubrication of Drive ShaftLubrication of FWD Drive Shaft Maintenance of the Rollover Protective Structure Rops Tire MaintenanceRemoving the Tractor from Storage Tractor StorageDaihatsu Emission Control Defects Warranty Coverage Engine Information and MaintenanceIgnition System Cleaning the Radiator SCREEN/RADIATOR Engine Maintenance Cleaning the EngineChecking Engine OIL Level Adding Engine OILChanging the Engine OIL and Filter Changing the Engine Coolant Checking Engine Coolant LevelInspection of Cooling System Hoses Changing the AIR Cleaner Changing The Fuel Filter Servicing the Fuel FilterDraining The Fuel Filter Specifications General Dimensions Power Take-OffHydraulic Lift System BrakesDescription Model Number Optional Equipment and AccessoriesCLEVELAND, Ohio CUB Cadet LLC Post Office BOX