•Turning adjustment bolt counter clockwise to increase steering lever travel.
2 | 3 | 1 |
1.Forward Travel Adjustment Bolt
2.Rear Travel Adjustment Bolt
3.Lower Control Arm
Figure 22
REPLACING PTO BELT
Remove
(Figure 23)
1.Lower mower deck to the ground.
2.Remove belt covers from mower deck.
CAUTION: Use care when releasing idler spring tension. Keep body parts well away from idler when performing this operation.
3.Hook a puller into idler hole and pull idler arm towards outside of unit until tension is removed from PTO belt.
| 3 | 4 | 5 |
|
|
| 6 |
2 | 1 |
|
|
|
|
| |
|
|
| 7 |
1. | Idler Spring |
|
|
2. | Electric Clutch |
| |
3. | PTO Belt |
|
|
4. | Idler Hole |
|
|
5. | Idler Pulley |
|
|
6. | Idler Arm |
|
|
7. | Belt Cover |
|
|
| Figure 23 | ||
4.Remove PTO belt from left mower deck pulley.
5.Slowly release idler arm until tension is removed from idler spring.
6.Remove PTO belt from mower deck and electric clutch.
Install
(Figure 23)
NOTE: Do not install PTO belt on left mower deck pulley in step 1.
1.Install PTO belt on electric clutch and mower deck.
2.Hook a puller into idler hole and pull idler arm towards outside of unit until PTO belt can be routed around left mower deck pulley.
3.Slowly release idler arm until idler pulley rests firmly against PTO belt.
4.Install belt covers on mower deck.
GB - 24