Cable-routing
In the case of the KOMPONENT 110 and KOMPONENT 104 (where stand is fitted), the cable(s) can be routed through a duct inside the stand to provide an invisible connection if so desired. See stand fitting instructions, supplied with the stands.
Note:
Fit the stand before passing the cable through the duct.
Advanced configuration options
A number of additional configuration options are available, as listed below, which will enhance the performance of your KOMPONENT loudspeakers. For full details, see the Advanced Features manual, which can be found on the Linn website at www.linn.co.uk. Alternatively, contact your Linn retailer or the Linn Helpline (Helpline details are listed at the back of this manual).
Passive
A single amplifier channel connects to a loudspeaker using two, three or four cables (note –
Passive
Two, three or four amplifier channels connect to a loudspeaker (note – quad- amping is not available for KOMPONENT 104).
AKTIV operation
The term ‘AKTIV’ refers to the proprietary Linn active crossovers and loudspeaker configuration, whereby the loudspeaker’s internal passive crossover is effectively replaced with external AKTIV crossovers.
This exerts a much greater degree of control over the processing of the audio signal, providing a more precise audio output to the drive units and therefore resulting in significantly improved sonic performance, compared with passive operation.
Important note:
AKTIV operation requires a modification to your loudspeakers and in some cases, your amplifiers, which must be carried out by an authorised Linn Retailer.
4
Connecting English 
KOMPONENT 110, 106 & 104
Owner’s Manual