Alamo 66 manual SGM-10

Page 13
(SBM-2)
(SBM-1)
(SGM-9)
(SGM-8)
(SGM-6)
(SGM-5)

SAFETY

WARNING! Extreme care should be taken when operating near loose objects such as gravel, rocks, wire, and other debris. Inspect the area before mowing. Foreign objects should be removed from the site to prevent machine damage and/or bodily injury or even death. Any objects that cannot be removed must be clearly marked and carefully avoided by the operator. Stop mowing immediately if blades strike a foreign object. Repair all damage and make certain rotor or blade carrier is balanced before resuming mowing.

WARNING!

WARNING!

Many varied objects, such as wire, cable, rope, or chains, can become entangled in the operating parts of the mower head. These items could then swing outside the housing at greater velocities than the blades. Such a situation is extremely hazardous and could result in serious injury or even death. Inspect the cutting area for such objects before mowing. Remove any like object from the site. Never allow the cutting blades to contact such items.

Avoid mowing in reverse direction when possible. Check to make sure there are no persons are behind the mower and use extreme care when mowing in reverse. Mow only at a slow ground speed where you can safely operate and control the tractor and mower. Never mow an area in the reverse direction that you have not inspected and removed debris or foreign material.

WARNING!

DANGER!

Do not put hands or feet under mower decks. Blade Contact can result serious injury or even death.

Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.

(SGM-10)

DANGER!

DANGER!

Rotary Mowers are capable under adverse conditions of throwing objects for great distances (100 yards or more) and causing serious injury or death. Follow safety messages carefully.

STOP MOWING IF PASSERSBY ARE WITHIN 100 YARDS UNLESS: -Front and Rear Deflectors are installed and in good, working condition;

-Mower Head is running close to and parallel to the ground without exposed Blades; -Passersby are outside the existing thrown-object zone;

-All areas have been thoroughly inspected and all foreign material such as rocks, cans, glass, and general debris has been removed.

NOTE:

Where there are grass and weeds high enough to hide debris that could be struck by the blades, the area should be: inspected and large debris removed, mowed at an intermedi- ate height, inspected closely with any remaining dsebris being removed, and mowed again at desired final height.

Use extreme caution when raising the Mower head. Stop the Blades from turning when the Mower Head is raised and passersby are within 100 yards. Raising the Mower head exposes the Cutting Blades which creates a potentially serious hazard and can cause serious injury by objects thrown from the Blades or by contact with the Blades.

GRIZZLY 66 01/05

Safety Section 1-7

© 2005 Alamo Group Inc.

Image 13
Contents Grizzly To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety ¡LEA EL Instructivo Do not mount the Tractor while the tractor is Following rules Safety SGM-10 Parts Information Wait a minute...Save a lifeWork Area Preparation Safety Safety Safety QTY Description Decal Location Decals Not Shown Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Safety First Page Assembly Section PRE-INSTALLATION AssemblyHydraulic Schematic Alternate Hydraulic Schematic Assembly Page Operation Section Pre-Startup OperationCheck LubricateStart Up Two Blade Arm, Three Blade Disc & Disc w/ Cutter BitsTwo Blade Arm w/ Blades Three Blade Rotary Disc Disc w/ Cutter BitsNormal Operation Maintenance Section General Maintenance MaintenanceDisassembly Series II Model AssemblyBikon Hub Bikon Torque Values Installation Installation & Removal of Locking AssemblyBlade Bolts Blade Arm & Bolt Torque ValuesMaintenance Removal General InstructionsGrizzly 66 01/05 Maintenance Section Alamo Industrial Required of the Owner To the OWNER/OPERATOR/DEALERGrizzly 66 01/05 02975193C Printed U.S.A