16What to do if…
Cleaning of the spark plug
This feature is obtained through a ceramic ignition candle with a metal electrode. Keep these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed.
Periodic maintenance
Periodically speak your local Service Force Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted.
WHAT TO DO IF…
Problem |
| Possible cause | Remedy |
|
|
|
|
There is no spark when lighting |
| • There is no electrical supply | • Make sure that the unit is |
the gas |
|
| connected and the electrical |
|
|
| supply is switched on. |
|
|
| • Control the fuse. If the fuse |
|
|
| is released more than one |
|
|
| time, refer to a qualified |
|
|
| electrician. |
|
|
|
|
|
| • Burner cap and crown are | • Make sure that the burner |
|
| placed uneven | cap and crown are in correct |
|
|
| positions. |
The flame is blow out immedi- |
| • Thermocouple is not heated | • After lightning the flame, |
ately after ignition |
| sufficient | keep the knob pushed for |
|
|
| approximately 5 seconds. |
|
|
|
|
The gas ring burns unevenly |
| • Burner crown is blocked | • Make sure that the injector |
|
| with food residues | is not blocked and the burn- |
|
|
| er crown is clear of food |
|
|
| particles. |
|
|
|
|
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre.
If you operated the appliance incorrectly, or the installation was not carried out by a regis- tered engineer, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period.