Basic Reminders About Your AeroGarden (continued)
Raise Lamp Hood (Lights)
As plants grow to
from lights, raise Lamp Arm one notch at a time (each of the three Lamp Arm sections has Lamp Arm is at the lowest setting when you start your AeroGarden 6 Elite+.
1Unplug AeroGarden 6 Elite+ and remove Bowl from Base.
3Replace Bowl on Base and plug in AeroGarden 6 Elite+.
2Raise Lamp Arm/Lamp Hood:
• Hold Lamp Arm where it connects to Lamp Hood with one hand. With other hand, push in Locking Lever.
• Release Locking Lever while pulling up on Lamp Arm.
• Locking Lever will automatically click into next notch in the Lamp Arm section.
Push Locking
Lever in
Push Locking
Lever in
Push Locking | Push Locking |
Lever in | Lever in |
Replace Grow Bulbs – Order bulbs at www.aerogardensupport.com
Add Nutrients 
Replace
Bulbs
When “Replace Bulbs” light on Control Panel begins blinking after 6 months of use…
•Unplug AeroGarden 6 Elite+.
•Remove old Grow Bulbs and carefully discard.*
IMPORTANT: To avoid burning, be sure Grow Bulbs are cool before handling.
•Insert new Grow Bulbs into Lamp Hood.
•Plug in AeroGarden 6 Elite+ and press and release “Reset” button to restart grow bulb timer.
Early Grow Bulb Replacement
If you replace Grow Bulbs before “Replace Bulbs” light illuminates, be sure to restart grow bulb timer as follows:
•Press and hold “Lights” button until light next to your selected plant type starts blinking – about 5 seconds.
•Release “Lights” button. The plant type selected light will continue to blink for about 9 seconds. While plant light is still blinking…
•Quickly press and release “Reset” button. “Replace Bulbs” light will blink once and the plant selected light will stop blinking.
*Check with local recycling authorities for light bulb recycling availability in your area.
12