AeroGarden PRO200 quick start Prepare For Your Next Garden, Place Pump Filter back into Pump Stand

Page 15

Prepare For Your Next Garden

Cleaning Instructions for your AeroGarden

Use only water and mild soap when cleaning your AeroGarden (except when Sanitizing - Step 7). Do not use abrasive cleaners or run through the dishwasher.

When your Garden has completed it’s growing cycle…

1Unplug AeroGarden.

2Carefully remove Bowl and Grow Surface from Base and bring to a sink. Set Base and Lamp Hood aside.

NEVER SUBMERSE BASE AND CONTROL PANEL IN WATER.

3Remove Grow Surface from Bowl and place on a counter near a sink.

4Empty contents of Bowl in sink.

5Remove Seed Pods and plants from Grow Surface.

Pull Seed Pods out of Grow Surface openings.

Throw away Seed Pods and plant debris (plant growth and roots). If you compost, plant debris can be composted.

6Rinse and clean Grow Surface, Pump Stand and Pump Filter.*

Use a soft scrub brush to clean tangled roots from underside of Grow Surface and Pump Stand.

Remove Pump Filter from Pump Stand. Gently scrub roots from Pump Filter.

Place Pump Filter back into Pump Stand.

After cleaning, there may still be a few roots in your Grow Surface, Pump Stand or Pump Filter. This will not affect the operation of your AeroGarden.

Grow

Surface

Plant

Growth

Seed

Pod

Roots

Pump

 

Stand

Pump

 

Filter

7Sanitize AeroGarden.

Fill Bowl ¾ full with water.

Add ¼ cup (59ml) of chlorine bleach.

Replace Grow Surface on Bowl, place Bowl on Base and plug in AeroGarden for 1-2 minutes.

(Select Salad Greens on Control Panel to be sure water is flowing.)

Unplug AeroGarden and empty bleach water from Bowl.

8Rinse AeroGarden.

Refill Bowl with tap water and replace on Base.

Plug in and run AeroGarden for 1-2 minutes. (Select Salad Greens again.)

Unplug AeroGarden, empty Bowl and repeat this step (step 8) one more time.

9Towel dry the Bowl and Grow Surface before putting them back together and setting them back on the Base.

10If your Grow Bulbs have been in use more than 6 months, they should be replaced at this time (see page 12).

Your AeroGarden is now ready for replanting.

*IMPORTANT NOTE: We recommend replacing the Pump Filter after growing two gardens. Order Pump Filters from www.aerogardensupport.com or from your retailer.

14

Image 15
Contents Simple Steps Important Safety Instructions Push Lamp Cord firmly into socket in Lamp Hood Quick Start Assembly No tools requiredPRO200 Into Base Insert Deluxe Grow Bulbs into Lamp HoodHood down Quick Start AssemblySet Bowl into Base Over Lamp ArmAway From Place Your GardenAdd Water Using a Spouted Container Planting Your GardenPlant Your Garden Touches Grow Surface Place Bio-Domeson Seed PodsAdd Starting Nutrient Tablets and Record Planting Date Place a Bio-Dome on each Seed PodPlug Cord into Electrical Outlet What will happen Starting Your GardenSelect Plant Type Your Light TimerSimple Steps Personalize Your Light Timer optionalAeroGarden PRO200 24-Hour Light Setting Personalize Your Light TimerAeroGarden PRO200 Control Panel Basic Reminders About Your AeroGardenInsert new Grow Bulbs into Lamp Hood Raise Lamp Arm/Lamp HoodClip Trellis Coil on Bracket Pull down Trellis Coil Insert Grow Bulbs into Lamp HoodPlace Pump Filter back into Pump Stand Prepare For Your Next GardenReplanting Your AeroGarden Bundle cord when furnishing is not in use