AeroGarden 100733-DSS Replanting Your AeroGarden, Bundle cord when furnishing is not in use

Page 16

Prepare For Your Next Garden (continued)

Replanting Your AeroGarden

If you have already grown a garden in your AeroGarden, please follow the instructions below to reset the nutrient timer:

•Press and HOLD “Reset” button until red “Add Nutrient” light blinks (approximately 9 seconds).

•Release “Reset” button. “Add Nutrient” light will turn off.

•Your AeroGarden is now reset. (In some cases you may see other lights blink as well. This is nothing to worry about.)

Reset

Add Nutrient

!Bundle cord when furnishing is not in use.

U.S. CAUTION – You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de- signed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guar- antee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver; Connect the equipment into an outlet on a circuit different from that to which the receiver is connected; or, Consult the dealer or an experienced radio/TV technician for help.

To reduce the risk of electric shock, this furnishing has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER UN CHOC ÉLECTRIQUE, PRÉSENTER LA LAME LARGE À LA FENTE LARGE ET POUSSER JUSQU’AU FOND.

PRO200

© 2007-2008 AeroGrow International, Inc., Boulder, CO U.S.A. U.S. Patents Pending

5/8/08

Page 15 Page 16
Image 16
Page 15 Page 16
Contents Simple Steps Important Safety Instructions Quick Start Assembly No tools required PRO200 Into BaseInsert Deluxe Grow Bulbs into Lamp Hood Push Lamp Cord firmly into socket in Lamp HoodQuick Start Assembly Set Bowl into BaseOver Lamp Arm Hood downPlace Your Garden Away FromPlanting Your Garden Add Water Using a Spouted ContainerPlant Your Garden Place Bio-Domeson Seed Pods Add Starting Nutrient Tablets and Record Planting DatePlace a Bio-Dome on each Seed Pod Touches Grow SurfaceStarting Your Garden Plug Cord into Electrical Outlet What will happenYour Light Timer Select Plant TypePersonalize Your Light Timer optional Simple StepsPersonalize Your Light Timer AeroGarden PRO200 24-Hour Light SettingBasic Reminders About Your AeroGarden AeroGarden PRO200 Control PanelRaise Lamp Arm/Lamp Hood Insert new Grow Bulbs into Lamp HoodInsert Grow Bulbs into Lamp Hood Clip Trellis Coil on Bracket Pull down Trellis CoilPrepare For Your Next Garden Place Pump Filter back into Pump StandBundle cord when furnishing is not in use Replanting Your AeroGarden
Top Page Image Contents