Cal Spas Portable Spas manual Light, Option, Automatic Time outs, Setting Filtration Cycles

Page 13

Light

Press the Light button to turn on the light. Press it once again to turn the light off. All optional lighting such as the control panel light and cabinet perimeter lighting is controlled by the Light button and will turn on and off with the spa light.

Option

Press the Option button to turn on the pump 2 on. Press it once again to turn off the pump 2 off.

Automatic Time outs

These features will automatically turn themselves off during periods of continuous use:

•

Low speed pump

After 4 hours

•

High speed pumps

After 15 minutes

•

Optional circulation pump

After 15 minutes

•

Optional turbo

After 15 minutes

•

Spa light

After 15 minutes

Operating Your Spa

Setting Filtration Cycles

Your spa is programmed to filter twice a day. The first cycle will begin 6 minutes after the spa is turned on and the second cycle 12 hours later. The factory has programmed the cycle to last for 2 hours but this can be switched to 4, 6, or 8 hours depending on your requirements. To set filtration time, turn off the power to the spa at the time of day you would like one of the filtration cycles to begin then turn back on after 30 seconds. When power has been restored, press the “Temp” button then the “Jets” button. Press “Temp” button again to change the filtering cycle duration. When desired duration is selected press the “Jets” button to exit.

At the beginning of each filtering cycle the Turbo system will run for approximately 30 seconds. The low speed pump will run for the duration of the filtering cycle and if an Ozone system is installed it will be activated. During filtering, “FC” will appear on the main display.

Diagnostic Messages

Message

Meaning

 

--

Spa temperature is unknown. After pump has been running for 2 minutes temperature will be

 

displayed.

 

HH

Overheat protection (spa is shutdown) DO NOT ENTER THE WATER!

One sensor has detected

 

118˚F (48˚C) at the heater. Remove the spa cover and allow spa to cool below 107˚F (42˚C). Press

 

any button on the topside display to reset spa. If spa will not reset after spa has cooled, turn off

 

power for approximately 30 seconds and then turn power back on. If display message is repeated

 

then shut the power off to the spa and call your dealer or service organization.

OH

Overheat protection (spa is shutdown) DO NOT ENTER THE WATER! If the spa has reached 110˚F

 

(43˚C), remove the spa cover to cool the water. At 107˚F (42˚C), the spa should reset itself. If the

 

spa does not reset, then shut the power off to the spa, wait 30 seconds and restore power to spa.

 

If display message is repeated then shut the power off to the spa and call your dealer or service

 

organization.

 

IC

A possible ice condition exists within the spa. No action is required, the pump will automatically

 

activate.

 

SA or Sb

Spa is shut down. Spa has detected that one of the sensors is not operating properly. One of these

 

may display briefly during overheat then disappear when overheat situation has been resolved. Call

 

your dealer or service organization if message does not go away.

 

Sn

Sensor (Spa is shut down). The high limit or water temperature sensors are not working correctly.

 

Call your dealer or service organization.

 

HL

A difference in readings between temperature sensors has been detected indicating a possible

 

water flow problem. Make sure spa is filled to proper level and that pumps are primed (water is

 

flowing). Also check to make sure filter cartridges are clean. If message does not reset, call your

 

dealer or service organization.

 

 

 

 

2009 Portable Spa Owner’s Manual

Page 13

LTR20091001, Rev. A

Page 12 Page 14
Image 13
Page 12 Page 14
Contents LTR20091001, Rev. a 12/15/08 Read This First Appendix Water Quality MaintenancePreparing for Your New Portable Spa Operating Your SpaRead This First Important Safety InstructionsBasic Spa Information Hyperthermia DangerRead This First Planning the Best Location Preparing for Your New Portable SpaPreparing a Good Foundation RCD and Wiring Requirements Volt Electrical InstallationTesting the RCD Breaker Spa Model Gfci Required Wires RequiredElectrical Installation for 8..5 kW Heater RCD Device RCD Wiring DiagramGas Heater Hook-up Preparing for Your New Portable Spa Filling and Powering Up Your Portable Spa 6205 Electronic Control Operation Operating Your SpaDiagnostic Messages Meaning Setting Filtration CyclesLight OptionMessage actions then press any button to reset 9005 Electronic Control Operation Preset Filter Cycles Setting the Temperature LockClean-up Cycle Option Optional BlowerPeriodic Reminder Messages Diagnostic MessagesMessage Meaning Action Required BUF Adjustable Jets Wireless Spa MonitorAuxiliary Control Operation Diverter Knobs Adjustable Therapy SystemAir Venturis Multi-Colored Spa Light Operation Pulse Mode SystemAromatherapy WaterfallsCal Spas Clear Water Plan Water Quality MaintenanceAlternative Sanitation Options Before You BeginBather Load Chemical SafetyChemical Overview Physical Chemical HazardsFor use with any Clear Water Plan Chemical DescriptionsFor use with the bromine Clear Water Plan For use with the chlorine Clear Water PlanFor use with the Cal Clarity Bromine Generator Start Up Traditional Chemical Start Up Bromine Clear Water PlanDay One Monday Day Two WednesdayOzonator Clear Water Plan Chlorine Clear Water PlanDay Two Friday Bromine Generator Clear Water PlanMaintenance Schedule Removing and Reseating the Pillows Cleaning and MaintenanceSpa Cover Draining Your Portable Spa Freeze damage is not covered by your warrantyWinterizing Cold Climate Draining Cleaning the Cover, Shell and Pillows Exclusive Bio-Clean Filter Cartridge Cleaning and Replacing the FilterPrior to Spa Start-Up Refilling Raising and Lowering Using the Entertainment SystemOperating the CD Player Playing a MovieUsing the Universal Remote Control Using the iPod Docking StationDevice Device Manufacturer Programming the Universal Remote ControlCode Appendix Replacement PartsMjlw Power Storm JET, Directional SXW Power Storm JET, Swirley Pillows ValvesDrains WaterfallsFilters Replacement Cabinet PanelsPumps LED LightsAvalon Series CoversClassic / Legacy Series CLASSIC/LEGACY Newporter 93 x Designer SeriesFamily Series Fitness SeriesVictory Xtreme Series Galaxy SeriesVX834B/L, VX848B/L, VX860B/L 93 x Fitness Series Exercise Program Keeping Fit with your Cal SpaConnecting the Exercise Equipment Cal Spas Chemicals International Portable Spas WarrantyWarranty Limitations and Exclusions Proration of WarrantyCustomer Service DisclaimersLocating the product serial number

Portable Spas specifications

Cal Spas Portable Spas are designed to offer a luxurious and relaxing experience in the comfort of your own backyard. Known for their innovation and quality, Cal Spas utilizes advanced technologies to provide users with an unparalleled spa experience.

One of the standout features of Cal Spas Portable Spas is their customizable massage systems. Each spa is equipped with multiple jet configurations that can be tailored to individual preferences, providing targeted relief for sore muscles and tension. The combination of adjustable jets and varying pressure settings offers a personalized massage experience that caters to every user's needs.

In addition to their massage systems, Cal Spas boasts energy-efficient heating technology. Their spas come with a high-performance heating system that rapidly warms the water while maintaining lower energy consumption. This not only keeps operational costs down but also allows users to enjoy their spa without long waiting periods for water to heat up.

Cal Spas emphasizes durability and quality in the construction of their portable spas. The shells are made from high-quality acrylic, which is both strong and resistant to fading, ensuring that the spa maintains its beautiful appearance over the years. The sturdy cabinet is designed to withstand outdoor conditions, featuring synthetic materials that resist moisture and UV damage, extending the lifespan of the spa.

For added convenience, many Cal Spas Portable Spas come equipped with smart technology features. Users can control settings such as temperature, jet settings, and lighting through a user-friendly interface or even via a mobile app, allowing for seamless control at your fingertips. This feature enhances the user experience by allowing individuals to set up their spa for use before they even step outside.

Moreover, Cal Spas are also designed with safety and comfort in mind. The ergonomic seating arrangements ensure that users are comfortable while relaxing or enjoying a massage. Many models include built-in safety features, such as easy-access steps and non-slip surfaces, to promote safe entry and exit.

With a variety of models available, Cal Spas provides options to suit different preferences and lifestyles. Whether you seek an intimate space for two or a larger spa for social gatherings, there’s a model that caters to your needs.

In conclusion, Cal Spas Portable Spas stand out not only for their luxurious features and customizable options but also for their commitment to quality and durability. Combining advanced technology, user-friendly controls, and a focus on relaxation, Cal Spas offers a premium spa experience designed for everyone.
Top Page Image Contents