Cal Spas Portable Spas manual Electronic Control Operation

Page 15

Operating Your Spa

8005 and 9005 Electronic Control Operation

When first powered up, the

electronic system

will perform

a

self-diagnostic

check

and

then it

will automatically

heat

to

and

maintain

a temperature

of 37.5˚C until you change the set temperature as listed in the “Temperature Adjustment” section below.

These instructions will describe features and options that your particular spa may not be equipped with.

Initial Start-up

When your spa is first powered up, it displays some configuration codes and then goes into priming mode (Pr will appear on the display panel). This mode lasts up to four minutes and then the spa begins to heat to its pre -programmed temperature of 37.5˚C. You can exit the priming mode early by pressing UP or DOWN buttons.

Temperature Adjustment (26.0˚C - 40.0˚C)

The start-up temperature is set at 37.5˚C. The last measured temperature is constantly displayed on the control panel. Note that the last measured spa temperature is displayed. The displayed temperature will be updated when the pump has been running for at least two minutes.

Press the UP or DOWN buttons once to display the set temperature. Each time either button is pressed again, the set temperature will increase or decrease depending on which button is pressed. After three seconds, the control panel will automatically display the last measured spa temperature.

Time

When time hasn’t been programmed, the TIME icon flashes. To set the time, press the TIME button and then the MODE/PROG button. Use the UP and DOWN buttons to adjust time. See the next page for more detailed instructions.

Standard, Economy, Sleep, and Standby Modes

Mode/Prog: This button is used to switch between standard, economy, and sleep modes.

1. Press MODE/PROG to enter mode programming.

2.Press the DOWN button to cycle through to the desired mode.

3.Press MODE/PROG to confirm selection.

Standard Mode: This is programmed to maintain the desired temperature. Note that the last measured spa temperature displayed is current only when the pump has been running for at least two minutes. The “STAND” icon will display until the mode is changed.

Economy Mode: Economy mode heats the spa to the set temperature only during filter cycles. The “ECON” icon will display until the mode is changed. Pressing the JETS 1 button while in economy mode puts the spa in standard-in-economy mode, which operates the same as standard mode but reverts back to economy mode automatically after one hour. During this time, pressing the MODE/PROG button will revert to economy mode immediately.

Sleep Mode: Sleep mode heats the spa to within 11˚C of the set temperature only during filter cycles. The “SLEEP” icon will display until the mode is changed.

Standby Mode: Pressing “Warm” or “Cool” then “Jets 2” will turn off all spa functions temporarily. This is helpful when changing a filter. Pressing any button resets the spa.

Jets 1 and Jets 2

Press the JETS 1 button once to turn pump 1 on or off and to shift between low and high speeds if equipped. If left running, the low speed turns off after two hours and the high speed turns off after 15 minutes. On non- circulation systems, the low speed of pump 1 runs when the blower or any other pump is on. It may also activate for at least two minutes every 30 minutes to detect the spa temperature and then to heat to the set temperature if needed, depending upon the mode. When the low speed

2009 Portable Spa Owner’s Manual

Page 15

LTR20091001, Rev. A

Image 15
Contents LTR20091001, Rev. a 12/15/08 Operating Your Spa Appendix Water Quality MaintenanceRead This First Preparing for Your New Portable SpaHyperthermia Danger Important Safety InstructionsRead This First Basic Spa InformationRead This First Preparing for Your New Portable Spa Planning the Best LocationPreparing a Good Foundation Spa Model Gfci Required Wires Required Volt Electrical InstallationRCD and Wiring Requirements Testing the RCD BreakerElectrical Installation for 8..5 kW Heater RCD Device RCD Wiring DiagramGas Heater Hook-up Preparing for Your New Portable Spa Filling and Powering Up Your Portable Spa 6205 Electronic Control Operation Operating Your SpaOption Setting Filtration CyclesDiagnostic Messages Meaning LightMessage actions then press any button to reset 9005 Electronic Control Operation Option Optional Blower Setting the Temperature LockPreset Filter Cycles Clean-up CycleDiagnostic Messages Periodic Reminder MessagesMessage Meaning Action Required BUF Wireless Spa Monitor Adjustable JetsAuxiliary Control Operation Adjustable Therapy System Diverter KnobsAir Venturis Waterfalls Pulse Mode SystemMulti-Colored Spa Light Operation AromatherapyBefore You Begin Water Quality MaintenanceCal Spas Clear Water Plan Alternative Sanitation OptionsPhysical Chemical Hazards Chemical SafetyBather Load Chemical OverviewFor use with any Clear Water Plan Chemical DescriptionsFor use with the chlorine Clear Water Plan For use with the bromine Clear Water PlanFor use with the Cal Clarity Bromine Generator Day Two Wednesday Traditional Chemical Start Up Bromine Clear Water PlanStart Up Day One MondayOzonator Clear Water Plan Chlorine Clear Water PlanDay Two Friday Bromine Generator Clear Water PlanMaintenance Schedule Cleaning and Maintenance Removing and Reseating the PillowsSpa Cover Freeze damage is not covered by your warranty Draining Your Portable SpaWinterizing Cold Climate Draining Cleaning the Cover, Shell and Pillows Cleaning and Replacing the Filter Exclusive Bio-Clean Filter CartridgePrior to Spa Start-Up Refilling Playing a Movie Using the Entertainment SystemRaising and Lowering Operating the CD PlayerUsing the Universal Remote Control Using the iPod Docking StationProgramming the Universal Remote Control Device Device ManufacturerCode Appendix Replacement PartsMjlw Power Storm JET, Directional SXW Power Storm JET, Swirley Waterfalls ValvesPillows DrainsLED Lights Replacement Cabinet PanelsFilters PumpsCovers Avalon SeriesClassic / Legacy Series CLASSIC/LEGACY Newporter 93 x Designer SeriesFamily Series Fitness SeriesVictory Xtreme Series Galaxy SeriesVX834B/L, VX848B/L, VX860B/L 93 x Fitness Series Exercise Program Keeping Fit with your Cal SpaConnecting the Exercise Equipment Cal Spas Chemicals International Portable Spas WarrantyDisclaimers Proration of WarrantyWarranty Limitations and Exclusions Customer ServiceLocating the product serial number

Portable Spas specifications

Cal Spas Portable Spas are designed to offer a luxurious and relaxing experience in the comfort of your own backyard. Known for their innovation and quality, Cal Spas utilizes advanced technologies to provide users with an unparalleled spa experience.

One of the standout features of Cal Spas Portable Spas is their customizable massage systems. Each spa is equipped with multiple jet configurations that can be tailored to individual preferences, providing targeted relief for sore muscles and tension. The combination of adjustable jets and varying pressure settings offers a personalized massage experience that caters to every user's needs.

In addition to their massage systems, Cal Spas boasts energy-efficient heating technology. Their spas come with a high-performance heating system that rapidly warms the water while maintaining lower energy consumption. This not only keeps operational costs down but also allows users to enjoy their spa without long waiting periods for water to heat up.

Cal Spas emphasizes durability and quality in the construction of their portable spas. The shells are made from high-quality acrylic, which is both strong and resistant to fading, ensuring that the spa maintains its beautiful appearance over the years. The sturdy cabinet is designed to withstand outdoor conditions, featuring synthetic materials that resist moisture and UV damage, extending the lifespan of the spa.

For added convenience, many Cal Spas Portable Spas come equipped with smart technology features. Users can control settings such as temperature, jet settings, and lighting through a user-friendly interface or even via a mobile app, allowing for seamless control at your fingertips. This feature enhances the user experience by allowing individuals to set up their spa for use before they even step outside.

Moreover, Cal Spas are also designed with safety and comfort in mind. The ergonomic seating arrangements ensure that users are comfortable while relaxing or enjoying a massage. Many models include built-in safety features, such as easy-access steps and non-slip surfaces, to promote safe entry and exit.

With a variety of models available, Cal Spas provides options to suit different preferences and lifestyles. Whether you seek an intimate space for two or a larger spa for social gatherings, there’s a model that caters to your needs.

In conclusion, Cal Spas Portable Spas stand out not only for their luxurious features and customizable options but also for their commitment to quality and durability. Combining advanced technology, user-friendly controls, and a focus on relaxation, Cal Spas offers a premium spa experience designed for everyone.