Liebert DS Moving the Unit to the Installation Location with Piano Jacks, Removing Piano Jacks

Equipment Inspection and Handling

5.2.2Moving the Unit to the Installation Location with Piano Jacks

1.With the Liebert DS elevated, place two piano jacks into position—one at either end of the unit.

2.Lower the unit to a height suitable for the piano jacks and place protective material between the Liebert DS and the piano jacks.

3.Secure the unit to the piano jacks and remove the forklift.

4.Use the piano jacks to move the unit for installation.

Figure 33 Moving the unit to its installation location

Step 1

Step 2

Step 3

181659P1 Rev. 5

5.2.3Removing Piano Jacks

1.Lower the unit as much as the piano jacks will allow.

2.Undo all strapping holding the piano jacks to the unit.

3.Use a pry bar or similar device to lift one end of the unit just enough to allow removal of the piano jack from that end.

4.Repeat Step 3 to remove the piano jack on the opposite end.

5.Remove all material that might have been used to protect the unit from the piano jacks and strapping.

38