Exmark Metro HP manual Grease Lubrication Chart, Spray Lubricant Chart

b)Remove deck support belt shield to check mower deck drive belt condition.

c)Look under engine deck to check the transmission drive and clutching belt condition.

d)Inspect wheel drive belt conditions

e)Check the wheel drive idler arms to be sure they pivot freely. Disassemble, clean and grease pivot bushings if necessary.

5.1.13Inspect PTO Clutching Belt Tension.

Service Interval: Check every 2 hrs. for first 8 hrs. operation then check every 40 hrs. thereafter.

a)Stop engine and wait for all moving parts to stop.

b)Engage PTO lever.

c)Look through the round hole in the left rear corner of the engine deck to inspect PTO clutching belt tension. Bolt on PTO engagement linkage bellcrank and indicator arm should align within 1/16” (See figure 14). Refer to section 5.2.2 for adjustment.

5.1.14Lubrication

Service Interval: Refer to Chart.

a)Stop engine, wait for all moving parts to stop, and remove key or spark plug wire(s).

b)Lubricate fittings with one to two pumps of NGLI grade no. 2 multi-purpose gun grease. Refer to the following chart for fitting locations and lubrication schedule.

GREASE LUBRICATION CHART

FITTING		INITIAL	QUANTITY		SERVICE
LOCATIONS		PUMP	36”	48”	INTERVAL
1.	Caster Wheel Bearings	12	2	2	8 hours
2.	Caster Pivots	2	2	2	8 hours
3.	Drive Wheel Idler Arm	2	2	2	8 hours
4.	PTO Engagement Bellcrank	1	1	1	40 hours
5.	Clutch Arm Pivot	1	1	1	40 hours
6.	Mower Deck Idler Pivots	2	1	1	Yearly
7.	Trans. Output Shaft Coupler	2	2	2	40 hours

No. 5 (Clutch Arm Pivot)

Located Under Engine Deck

No. 7 (Trans. Coupler)

Located Below Fuel Tank Support

No. 3 (Idler Arm Pivots)

Disassemble and grease once a

Month under a “No Load” condition

c) Lubricate pivot points with a spray penetrating lubricant as directed below.

SPRAY LUBRICANT CHART

PIVOT POINT		NO. OF	SERVICE
		PLACES	INTERVAL
1. PTO Engagement Lever		1	Weekly
	- 23 -