Exmark 4500-689 manual Clean Debris From Machine, Clean Grass Build-Up Under Deck, Waste Disposal

Page 35
Clean Debris From Machine

Maintenance

Clean Debris From Machine

Service Interval: Before each use or daily

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.

2.Clean off any oil, debris, or grass build-up on the machine and cutting deck, especially under deck belt shields, around the fuel tank, around engine and exhaust area.

Clean Grass Build-Up Under

Deck

Service Interval: Before each use or daily

1.Disengage PTO.

2.Stop engine and wait for all moving parts to stop. Engage parking brake. Remove key or spark plug wire(s).

3.Raise deck and support unit using jack stands or equivalent support.

Clean Grass Build-Up UnderWaste Disposal CAUTION

Raising the mower for service or maintenance relying solely on mechanical or hydraulic jacks could be dangerous. The mechanical or hydraulic jacks may not be enough support or may malfunction allowing the unit to fall, which could cause injury.

Do Not rely solely on mechanical or hydraulic jacks for support. Use adequate jack stands or equivalent support.

4.Clean out any grass build-up from underside of deck and in discharge chute.

Waste Disposal

Motor Oil Disposal

Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at a certified recycling center or according to your state and local regulations.

35

Image 35
Contents For Serial Nos 920,000 & Higher METROAll Rights Reserved CALIFORNIA Proposition 65 WarningModel No Serial No IntroductionContents ALERT! YOUR SAFETY IS INVOLVED SafetySafety Alert Symbol SafetyKeep away from eyes and skin Never siphon by mouth DANGERAvoid prolonged breathing of vapors Keep face away from nozzle and gas tank/container openingRemove accumulated debris from muffler and engine area OperationSlope Operation Allow engine parts, especially the muffler, to cool before touchingDo Not mow near drop-offs or near water Maintenance and StorageDo Not mow slopes when grass is wet Mow across slopes, never up and downSafety and Instructional Decals 103-2245 1-403143 98-5954 103-1623103-1798 103-2076 103-2244Pistol Grip Units Only 117-2718 103-562648 inch Deck Units Only 103-1967Model Numbers SpecificationsSpecifications Safety Interlock SystemCutting Deck DimensionsCurb Weight Torque RequirementsOperation Product OverviewOperation ControlsDrive Levers “Off-Run” SwitchChoke Control Throttle ControlStarting the Engine Pre-StartOperating Instructions Open the Fuel Shut-Off ValveFor ECS Handles Driving the MachineDrive Lever/Neutral Lock/Park Brake Latch Operation For Pistol Grip HandlesChanging Gears Keep feet and legs out from under the unit when loading and unloadingIf necessary, use assistance when loading TransportingMaintenance MaintenanceRecommended Maintenance Schedules Check Engine Oil Level Periodic MaintenanceService Interval Before each use or daily Service Interval As requiredCheck for Loose Hardware Check Safety Interlock SystemService Air Cleaner SERVICE DEALERChange Engine Oil Service Interval After the first 5 hoursService Interval Every 40 hours Note See chart for service intervalsChange Fuel Filter Service Interval Every 160 hoursService Interval Every 500 hours Check Spark PlugsDielectric Grease Thread Locking AdhesivesMobil HTS Grease Or Food-Grade Anti-seize Copper-Based Anti-seizeAdjusting the Cutting Height AdjustmentsAdjusting the Axle Position Adjusting the Cutting Height with Blade Spacers Adjusting the Number of Spacers below Caster Support HubTransmission Belt AdjustmentWheel Drive Belt Pulley Scrapers Engine to Mower Deck BeltCheck belt tension after the first hour of operation Blade Brake Adjustment48 inch Belt Guide Location Viewed from underneath the deck Belt Guide AdjustmentBrake and Wheel Drive Linkage Adjustment Shown with Blades DisengagedLeft Side Shown Shifter Lever Adjustment Wheel Drive Spring Tension Adjustment Shifter Detent AdjustmentPTO Safety Switch Adjustment Handle Height AdjustmentClean all debris from engine and exhaust system area CleaningClean Engine and Exhaust System Area Remove Engine Shrouds and Clean Cooling FinsMotor Oil Disposal Clean Debris From MachineClean Grass Build-Up Under Deck Waste DisposalTroubleshooting TroubleshootingCutting blades is/are bent or unbalanced Schematics SchematicsOwner’s Responsibilities Exmark Commercial Turf Equipment2 Year Limited Warranty Instructions for Obtaining Warranty ServicePage Description of Work Done Service RecordService Done By DatePage This page may be copied for personal use WALK-BEHIND ACCESSORIES AND OPTIONS SEE EXMARK’S COMPLETE LINE OF ACCESSORIES AND OPTIONSMID-MOUNT RIDING ACCESSORIES AND OPTIONS OUT-FRONT RIDING ACCESSORIES AND OPTIONS