Exmark 4500-689 manual Safety and Instructional Decals

Page 9
Safety and Instructional Decals

Safety

Safety and Instructional Decals

Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and instructional labels.

Replace all worn, damaged, or missing safety signs.

When replacement components are installed, be sure that current safety signs are affixed to the replaced components.

If an attachment or accessory has been installed, make sure current safety signs are visible.

New safety signs may be obtained from your authorized Exmark equipment dealer or distributor or from Exmark Mfg. Co. Inc.

Safety signs may be affixed by peeling off the backing to expose the adhesive surface. Apply only to a clean, dry surface. Smooth to remove any air bubbles.

Familiarize yourself with the following safety signs and instruction labels. They are critical to the safe operation of your Exmark commercial mower.

1-303508

1-323427

32 inch and 36 inch Units Only

1-303517

1-303518

1-323550

 

 

 

 

 

 

Pistol Grip Handle Units Only

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1-403005

9

Image 9
Contents For Serial Nos 920,000 & Higher METROAll Rights Reserved CALIFORNIA Proposition 65 WarningModel No Serial No IntroductionContents Safety Alert Symbol SafetySafety ALERT! YOUR SAFETY IS INVOLVEDAvoid prolonged breathing of vapors DANGERKeep face away from nozzle and gas tank/container opening Keep away from eyes and skin Never siphon by mouthSlope Operation OperationAllow engine parts, especially the muffler, to cool before touching Remove accumulated debris from muffler and engine areaDo Not mow slopes when grass is wet Maintenance and StorageMow across slopes, never up and down Do Not mow near drop-offs or near waterSafety and Instructional Decals 103-1798 1-403143 98-5954 103-1623103-2076 103-2244 103-224548 inch Deck Units Only 117-2718 103-5626103-1967 Pistol Grip Units OnlySpecifications SpecificationsSafety Interlock System Model NumbersCurb Weight DimensionsTorque Requirements Cutting DeckOperation Product OverviewControls OperationChoke Control “Off-Run” SwitchThrottle Control Drive LeversOperating Instructions Pre-StartOpen the Fuel Shut-Off Valve Starting the EngineDrive Lever/Neutral Lock/Park Brake Latch Operation Driving the MachineFor Pistol Grip Handles For ECS HandlesIf necessary, use assistance when loading Keep feet and legs out from under the unit when loading and unloadingTransporting Changing GearsMaintenance Recommended Maintenance SchedulesMaintenance Service Interval Before each use or daily Periodic MaintenanceService Interval As required Check Engine Oil LevelService Air Cleaner Check Safety Interlock SystemSERVICE DEALER Check for Loose HardwareService Interval Every 40 hours Service Interval After the first 5 hoursNote See chart for service intervals Change Engine OilService Interval Every 500 hours Service Interval Every 160 hoursCheck Spark Plugs Change Fuel FilterMobil HTS Grease Or Food-Grade Anti-seize Thread Locking AdhesivesCopper-Based Anti-seize Dielectric GreaseAdjusting the Cutting Height AdjustmentsAdjusting the Axle Position Adjusting the Cutting Height with Blade Spacers Adjusting the Number of Spacers below Caster Support HubWheel Drive Belt Pulley Scrapers AdjustmentEngine to Mower Deck Belt Transmission BeltCheck belt tension after the first hour of operation Blade Brake AdjustmentBrake and Wheel Drive Linkage Adjustment Belt Guide AdjustmentShown with Blades Disengaged 48 inch Belt Guide Location Viewed from underneath the deckLeft Side Shown Shifter Lever Adjustment PTO Safety Switch Adjustment Shifter Detent AdjustmentHandle Height Adjustment Wheel Drive Spring Tension AdjustmentClean Engine and Exhaust System Area CleaningRemove Engine Shrouds and Clean Cooling Fins Clean all debris from engine and exhaust system areaClean Grass Build-Up Under Deck Clean Debris From MachineWaste Disposal Motor Oil DisposalTroubleshooting TroubleshootingCutting blades is/are bent or unbalanced Schematics Schematics2 Year Limited Warranty Exmark Commercial Turf EquipmentInstructions for Obtaining Warranty Service Owner’s ResponsibilitiesPage Service Done By Service RecordDate Description of Work DonePage This page may be copied for personal use MID-MOUNT RIDING ACCESSORIES AND OPTIONS SEE EXMARK’S COMPLETE LINE OF ACCESSORIES AND OPTIONSOUT-FRONT RIDING ACCESSORIES AND OPTIONS WALK-BEHIND ACCESSORIES AND OPTIONS