FIGURE 1
UPPER HANDLE MOUNTING
3.8Route the throttle cable along the right side of the upper handle, through the clip, under the fuel tank support, and position the cable on the left side of the engine.
Attach throttle cable to engine:
a)Position the throttle control lever (located on console) ¼” (6mm) from the upper end of the slot.
b)Attach inner wire of the throttle cable to the top hole in the throttle control lever as shown in Figure 2.
c)Loosen the clamp, place the cable behind it, and pull on the cable to move the throttle linkage to the full throttle position. Tighten the cable clamp screw.
FIGURE 2
SPEED CONTROL (THROTTLE CABLE HOOK-UP)
3.9Connect the PTO engagement linkages. Loosen jam nut and remove turnbuckle from lower linkage. Screw turnbuckle onto both upper and lower linkages simultaneously. (See figure 3) Note that the threads on upper linkage are left hand. See 5.2.2 for linkage adjustment.
Note: ECS handles have the PTO linkage on the inside of the PTO engagement lever tab and the hairpin on the outside.
FIGURE 3
PTO ENGAGEMENT LINKAGE
- 11 -