Exmark M216KASPC manual Operation, Controls, Starting the Engine, Stopping the Engine

3.Fill the fuel tank with unleaded gasoline to within 1/4 to 1/2 inch (6 to 13 mm) from the top of the tank. Do not fill into the filler neck.

Important Do not fill the tank more than 1/4 inch

(6 mm) from the top of the tank because the gasoline must have room to expand.

4.Install the fuel tank cap and wipe up any spilled gasoline.

Operation

Note: Determine the left and right sides of the machine from the normal operating position.

Each time before you mow, make sure that the self-propel drive and the blade control bail operate properly. When you release the blade control bail, the blade and self-propel drive should stop. If they do not, contact an Authorized Service Dealer.

Caution

This machine produces sound levels in excess of 85dBA at the operator's ear and can cause hearing loss through extended periods of exposure.

Wear hearing protection when operating this machine.

Controls

The blade control bail and throttle control are on the upper handle as shown in Figure 8.

2

1

222

Figure 8

1. Blade control bail 2. Throttle control

Starting the Engine

1.Connect the wire to the spark plug (Fig. 9).

1

m-7280

Figure 9

1.Spark-plug wire

2.Open the fuel valve (Fig. 3).

3.Move the throttle control to the (Choke) position

(Fig. 8).

4.Move the ground speed control to the (Neutral) position (Fig. 10).

1 224

Figure 10

1. Ground speed control

5.Pull the starter handle (Fig. 7) lightly until you feel resistance, then pull it sharply. Allow the rope to return slowly.

6.Regulate the throttle and the ground speed control as desired when the engine starts.

Note: If the engine fails to start after 3 pulls, repeat steps 3 through 6.

Stopping the Engine

1.Release the blade control bail and move the throttle

control to the (Off) position.

2.Disconnect the wire from the spark plug if you do not use the lawn mower or if you leave it unattended.

9