Exmark Frontrunner manual Specifications

Page 17

2.SPECIFICATIONS

2.1MODEL NUMBER: FR25KD

2.2ENGINE

2.2.1Engine Specifications: See your Engine Owner’s Manual

2.2.2RPM: Full Speed: 3870 RPM (No Load) +50/-100 RPM Idle: 1400 RPM (No Load) ±50 RPM

2.3FUEL SYSTEM

2.3.1Capacity: 8.5 gal (32 L)

2.3.2Type of Fuel: Diesel fuel, 40 cetane or higher.

2.3.3Fuel Filter: 2 In-line 15 Micron Kubota P/N 12581-43012, before and after the electric fuel pump.

2.4ELECTRICAL SYSTEM

2.4.1Charging System: External Alternator

2.4.2Charging Capacity: 60 amps

2.4.3Battery Type: BCI Group 26

2.4.4Battery Voltage: 12 Volt

2.4.5Polarity: Negative Ground

2.4.6Safety Interlock System:

PTO must be disengaged, brake engaged, and speed control lever in neutral position to start engine. (It is not necessary for the operator to be in the seat to start the engine.)

Operator must be in seat when PTO is engaged, brake is disengaged, or speed control lever is moved out of neutral or engine will stop.

Engine will stop if the motion control levers are moved from neutral position while brake is engaged.

2.5COOLING SYSTEM

2.5.1Fan: Belt driven with continuous operation with engine running.

2.5.2Coolant Liquid: 50/50 mix of DexCool© extended life antifreeze and water.

2.5.3Coolant Capacity: 4 quarts

2.6OPERATOR CONTROLS

2.6.1Steering and Motion Control:

Separate levers, on each side of the console, control speed and direction of travel of the respective drive wheels.

Steering is controlled by varying the position of the levers relative to each other. Moving motion control levers outward (in slots) locks the drive system in neutral. NOTE: Motion control levers are adjustable to three (3) heights.

2.6.2PTO Engagement Switch: Engages drive to PTO (mower deck).

2.6.3Parking Brake Lever: Pull back to engage parking brake.

2.7SEAT

2.7.1Type: Standard seat with high back, foam padded (internal suspension).

2.7.2Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other components. The seat is held in the tilted position with a linkage. Adjustable fore and aft seat track.

12

Image 17
Contents Model No Serial No Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Your Safety is Involved SafetySafety Alert Symbol TrainingCarbon monoxide can kill you Diesel fuel is flammable Operation When feasible, avoid operating the equipment in wet grass There is no rollover protection when the roll bar is down Page Maintenance and Storage Safety Signs Page Page Specifications Tires DimensionsHydrostatic Ground Drive System Controls Operation InstructionsTorque Requirements Glow Plug Chart Page Operating Instructions PRE-STARTRotating blades under the mower deck are dangerous Transporting Tip-over of the unit could cause serious injury or death Service Interval Daily Maintenance & AdjustmentsPeriodic Maintenance Service Interval Monthly Check the kill circuits Service Interval Daily or more often in dry conditionsService Interval Daily Check starting circuit PTO must not engage Check the PTO circuitService air cleaner Potential Hazard Do not overtighten Service Interval 40 hrService Interval 40 hrs Service Interval Once Yearly Service Interval Refer to chartService Interval 160 hrs Service Interval 400 hrs. or as required Service Interval YearlyFirst Interval 250 hrs Normal Interval Yearly Spring Tensioned No adjustment necessary AdjustmentsPage Potential Hazard Set neutral Page Weight transfer springs may have stored energy Motor OIL Disposal Battery DisposalWaste Disposal Mower Pulls Left or Right W/LEVERS Fully Forward Trouble ShootingMower Cuts Unevenly Engine will not StartEngine Warning Systems Troubleshooting TableElectrical Diagram Hydraulic Diagram Year Limited Warranty Exmark Turf Equipment Page Page Page See EXMARK’S Complete Line of Accessories