Exmark Frontrunner manual Potential Hazard

Page 39

FIGURE 12

h)If the linkage does not measure 7-3/8” (18.7 cm) or still does not disengage as desired, remove the bolt that secures the ball joint to the brake lever and loosen the jam nut next to the ball joint. Rotate the ball joint in half-turns counter-clockwise until desired disengagement is obtained.

i)Repeat procedure for other side.

4.2.5Motion control linkage adjustment:

WARNING

POTENTIAL HAZARD

Engine must be running and drive wheels must be turning so motion control adjustment can be performed.

WHAT CAN HAPPEN

Contact with moving parts or hot surfaces may cause personal injury.

HOW TO AVOID THE HAZARD

Keep fingers, hands, and clothing clear of rotating components and hot surfaces.

CAUTION

POTENTIAL HAZARD

Raising the unit for service or maintenance relying solely on mechanical or hydraulic jacks could be dangerous.

WHAT CAN HAPPEN

The mechanical or hydraulic jacks may not be enough support or may malfunction allowing the unit to fall, which could cause injury.

HOW TO AVOID THE HAZARD

DO NOT rely solely on mechanical or hydraulic jacks for support. Use adequate jack stands or equivalent

34

Image 39
Contents Model No Serial No Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Training SafetyYour Safety is Involved Safety Alert SymbolCarbon monoxide can kill you Diesel fuel is flammable Operation When feasible, avoid operating the equipment in wet grass There is no rollover protection when the roll bar is down Page Maintenance and Storage Safety Signs Page Page Specifications Dimensions Hydrostatic Ground Drive SystemTires Operation Instructions Torque RequirementsControls Glow Plug Chart Page Operating Instructions PRE-STARTRotating blades under the mower deck are dangerous Transporting Tip-over of the unit could cause serious injury or death Maintenance & Adjustments Periodic MaintenanceService Interval Daily Service Interval Monthly Service Interval Daily or more often in dry conditions Service Interval Daily Check starting circuitCheck the kill circuits PTO must not engage Check the PTO circuitService air cleaner Potential Hazard Service Interval 40 hr Service Interval 40 hrsDo not overtighten Service Interval Once Yearly Service Interval Refer to chartService Interval 160 hrs Service Interval 400 hrs. or as required Service Interval YearlyFirst Interval 250 hrs Normal Interval Yearly Spring Tensioned No adjustment necessary AdjustmentsPage Potential Hazard Set neutral Page Weight transfer springs may have stored energy Battery Disposal Waste DisposalMotor OIL Disposal Engine will not Start Trouble ShootingMower Pulls Left or Right W/LEVERS Fully Forward Mower Cuts UnevenlyEngine Warning Systems Troubleshooting TableElectrical Diagram Hydraulic Diagram Year Limited Warranty Exmark Turf Equipment Page Page Page See EXMARK’S Complete Line of Accessories