Operation
stopped before clearing blower assembly or mower deck.
3.To remove the bags, first disengage the PTO, stop the engine and wait for all moving parts to stop. Open the hopper and remove the bags by lifting up on the rear of the bag, then unhooking the front clip. Empty the bags by inverting them.
4.Reinstall bags, close and latch hopper before continuing mowing.
Tips for mowing conditions:
•When mowing in areas with sandy soil, use low lift blades on the cutting deck and higher cutting heights to minimize wear on the blower components.
•When mowing in wet conditions, such as just after a rain or in heavy dew, use low lift blades on the cutting deck to minimize plugging of the blower.
•Maintaining a ground speed that does not pull down the engine RPM will allow for the highest productivity and best quality of cut. Bogging the engine RPM down by going too fast will cause plugging and quality of cut issues.
•When the Ultra Vac gets full, the sound of the blower will change and there will be slight blowout from the front right corner of the deck. Emptying the Ultra Vac at this point will minimize the potential for the tube to plug.
Figure 5
1. | Hopper | 7. | Toe board weight |
2. | Reinforced bumpers | 8. | Belt cover |
3. | Clevis pin | 9. | Blower |
4. | Caster arm weight | 10. | Tubes |
5. | Hairpin | 11. | Bag |
6.For LZUV3B Units Only
4.Remove the knob from the belt cover bracket and take off the belt cover.
Collection System Removal for Side Discharge
1. Empty the hopper.
CAUTION
The hopper assembly is heavy when it is full, which may make it difficult to remove the hopper assembly from the unit. The entire hopper assembly may fall, which may cause injury.
Prior to removing the hopper assembly from the unit, first empty the contents.
2.Disengage the PTO, stop engine and wait for all moving parts to stop. Remove key and engage parking brake.
3.Remove the discharge tube by releasing the latches at the blower. Slide the tube off the blower outlet and remove the upper end from the hopper.
|
| Figure 6 |
|
1. | Belt cover bracket | 4. | Belt |
2. | Belt cover | 5. | Deck sheave |
3.Knob
12