Exmark TT23KAC, TT23KCC, TT20KCC manual Left Hand Side Shown

Page 33

LEFT HAND

SIDE SHOWN

FIGURE 7

CUTTING HEIGHT ADJUSTMENT

FIGURE 8

ANTI-SCALP ROLLER BOLT INSTALLATION

ANTI-SCALP ROLLER ADJUSTMENT

CUTTING HEIGHT ADJUSTMENT

b)Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one of the positions shown in Figure 8. Rollers will maintain 3/4 in. (19

mm)clearance to the ground to minimize gouging and roller wear or damage. For Maximum Deck Flotation, place rollers one hole position lower. Rollers should maintain 1/4 in. (6.4 mm) clearance to ground. Do Not adjust rollers to support the deck. Be sure roller bolts and nuts are installed with the spring disc washer between head of the bolt and mounting bracket. Torque to 40-45ft-lbs, or loss of roller may result.

c)When operating in extremely rough conditions it may be necessary to position the anti-scalp rollers one or two holes higher than described in "b" to prevent damage to the rollers and/or bolt failure (See Figure 8).

NOTE: When anti-scalp rollers are placed in these positions, reduced deck floatation will result.

5.2.2Pump drive belt tension adjustment: No adjustment necessary.

5.2.3Mower deck drive belt: No adjustment necessary.

-28 -

Image 33
Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Table of Contents Safety Alert Symbol SafetyYour Safety is Involved TrainingCarbon monoxide can kill you Potential Hazard Operation Page Maintenance and Storage Riding Attachments Safety SignsPage Specifications Assembly Instructions Charging the battery may produce explosive gasses Mower Deck Installation Drive WheelsSupport PIN Location Perform Necessary Adjustments Service Hydraulic OILGrease Unit Familiarize Yourself with the ControlsDrive LEVER, Neutral Lock Latch Operation InstructionsOperating Instructions PRE-STARTPotential Hazard Drive LEVER, Neutral Lock Latch Operation Maintenance & Adjustments Periodic MaintenanceTransporting Clean engine air cooling system Blade Bolt Installation Page Page Service Interval After First 250 hrs, then yearly thereafter Charge Pump Location Locations Pumps Places Interval Lubrication ChartPage Adjustments Left Hand Side Shown Hydro Drive Linkage Adjustment Neutral Safety Switch AdjustmentHydro Control LINKAGE/SWIVEL Adjustment Hydro Pump Spring Tension Setting Waste Disposal Trouble ShootingEngine Troubleshooting Engine Troubleshooting TableProblem Hydraulic Schematic Wiring Diagrams Limited Warranty Exmark Commercial Turf Equipment WarrantyPage Fold Along Appropriate Line See EXMARK’S Complete Line of Products for Turf Care