Reference
Typical Control Center Layout
| 10 | 3 | 1 |
|
|
|
|
|
| ||
|
|
| 2 |
|
|
|
|
| 4 |
| 5 |
|
|
|
|
| |
7 | 9 11 |
|
|
|
|
|
| 15 | 17 |
|
|
8 | 12 |
|
| 6 |
|
|
|
|
|
| |
|
| 13 |
| 16 14 | 18 |
|
|
|
| ||
|
|
|
|
|
1. | Primary Fuses — provides proper fusing to low | 10. | Exhaust Fuses (optional) — provides proper |
| voltage transformer. |
| fusing for exhaust fan motor(s). |
2. | Low Voltage Transformer — provides low | 11. | Exhaust Motor Starter (optional) — 24 volt |
| voltage to controls and optional evaporative |
| magnetic contacts for starting exhaust motor. |
| cooling controls. | 12. | Exhaust Overload (optional) — provides |
3. | Low Voltage Fuse — provides proper fusing |
| electronic overload protection to exhaust motor. |
| to controls and optional evaporative cooling | 13. | Inlet Air Sensor (optional) — outdoor air stat |
| controls. |
| that automatically controls the cooling based on |
4. | Control Terminal Block — provides wiring |
| outdoor air temperature. |
| access to controls. | 14. | Cooling Relay (optional) — allows power to |
5. | Building Freeze Protection Timer (optional) — |
| pass to cooling controls. |
| prevents the discharge of cold air into the | 15. | Reset Timer (optional) — resets cooling system |
| building. |
| to run a time interval. |
6. | Fan Relay — allows power to pass to energize | 16. | Auto Drain Relay (optional) — assures supply |
| motor starter. |
| pump does not operate during drain interval. |
7. | Supply Motor Starter — 24 volt magnetic |
| Allows pump to operate in cooling mode. |
| contacts for starting supply motor. | 17. | Cooling Timer (optional) — allows for |
8. | Supply Overload — provides electronic |
| automatic draining of the evaporative cooling |
| overload protection to supply motor. |
| system based on time schedule. |
9. | Auxiliary Contact (optional) — provides one | 18. | Dirty Filter Switch (optional) — monitors filter |
| normally closed and one normally open contact |
| pressure drop, turns on indicating light when |
| for other equipment. |
| pressure drop is above field adjustable set point. |
Dirty Filter Switch
Common
Normally Open
Normally Closed
CCW to Decrease Trip Point
CW to Increase Trip Point
Negative Pressure
after the filters
Positive Pressure before the filters
® | Model MSX | 37 |