2.Never allow children or people unfamiliar with the instruc- tions to use the machine.
3.Stop using the machine while people, especially children, or pets are nearby.
4.Only use the product in the manner and for the func- tions described in these instructions.
5.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.
6.The operator or user is responsible for accidents or haz-
ards occurring to other people or their property.
Electrical
1.The British Standards Institute recommend the use of a Residual Current Circuit Device (R.C.D.) with a tripping current of not more than 30mA. Even with a R.C.D. in- stalled 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.
2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.
3.Do not use the product if the electric cables are dam- aged or worn
4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.
5.Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your product.
6.Keep cable away from product, always work away from the power point mowing up and down, never in circles.
7.Do not pull cable around sharp objects.
8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.
9.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo re- placement cable.
10.Always wind cable carefully, avoiding kinking.
11.Never carry the product by the cable.
12.Never pull on the cable to disconnect any of the plugs.
13.Use only on AC mains supply voltage shown on the product rating label.
14.Flymo Products are double insulated to EN60335. Under no circumstance should an earth be connected
to any part of the product.
Preparation
1.While using your product always wear substantial footwear and long trousers.
2.Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade.
3.Before using the machine and after any impact, check for
signs of wear or damage and repair as necessary.
4.Replace worn or damaged blades together with their
fixings in sets to preserve balance.
Use
1.Use the product only in daylight or good artificial light.
2.Avoid operating your product in wet grass, where feasible.
3.Take care in wet grass, you may lose your footing.
4.On slopes, be extra careful of your footing and wear
5.Mow across the face of slopes, never up and down.
6.Exercise extreme caution when changing direction on slopes. Walk never run.
7.Mowing on banks and slopes can be dangerous. Do not mow on banks or steep slopes.
8.Do not walk backwards when mowing, you could trip.
9.Never cut grass by pulling the product towards you.
10.Switch off before pushing the product over surfaces other than grass.
11.Never operate the product with damaged guards or without guards in place.
12.Keep hands and feet away from the cutting means at all times and especially when switching on the motor.
13.Do not tilt product when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before return- ing the appliance to the ground.
14.Do not put hands near the grass discharge chute.
15.Never pick up or carry a product when it is operating or still connected to the mains supply.
16.Remove the plug from the mains :
-before leaving the product unattended for any period;
-before clearing a blockage;
-before checking, cleaning or working on the appliance;
-if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition.;
-if the product starts to vibrate abnormally. Check immedi-
ately. Excessive vibration can cause injury.
Maintenance and storage
1.Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition.
2.Check the grassbox frequently for wear or deterioration.
3.Replace worn or damaged parts for safety.
4.Only use the replacement blade, and blade bolt speci- fied for this product.
5.Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine.
6.Store in a cool dry place and out of reach of children. Do not store outdoors.
CABLES - IMPORTANT | 1. | No earth required. Flymo products are double insulated to | |||||
• | Use only 1.00mm2 size cable up to 40 metres length |
|
| EN60335 and under no circumstances should an earth be | |||
| maximum. |
|
| connected to any part of the product. | |||
Maximum rating : | 2. | Ensure the mains voltage suits your product | |||||
1.00mm2 size cable, 10 amps 250 volts AC. | 3. | IMPORTANT! |
|
| |||
• | YOUR PRODUCT IS SUPPLIED WITH CABLE |
|
| The wires in the mains lead are coloured in accor- | |||
| WIRED DIRECTLY INTO THE PRODUCT. |
|
| dance with the following code: | |||
1. | Flymo Mains Cables and Extension Cables are available |
|
| BLUE | - | NEUTRAL | |
| from your local Approved Service Centre. |
|
| BROWN | - | LIVE | |
2. | Do not wire an extension cable directly to your product |
|
| The wire which is coloured BLUE must be connected | |||
| yourself. Please contact your local Approved Service |
|
| to the Terminal which is marked with the letter 'N' or | |||
| Centre for further information on the connectors and |
|
| coloured BLACK. | |||
| kits available. |
|
| The wire which is coloured BROWN must be con- | |||
3. | Only use extension cables specifically designed for |
|
| nected to the Terminal which is marked with the letter | |||
| outdoor use. |
|
| 'L' or coloured RED. | |||
CONNECTORS - IMPORTANT | 4. | It is important that the outer sheath is clamped cor- | |||||
• | Flymo connectors are suitable for use with 2 core |
|
| rectly into the | |||
| cable only. Under no circumstances should these con- | 5. | If in doubt consult your local Service Repairer or quali- | ||||
| nectors be used for earthed products. |
|
| fied electrician before the machine is used. | |||
• | All Flymo connectors and cables are of splashproof | 6. | A 13 Amp fuse must be fitted to the Mains Plug. | ||||
| construction. They are not waterproof and must not be | 7. | The normal plug fuse and household fuse only protect | ||||
| left outside permanently nor should they be submerged |
|
| the electrical equipment and are not a safeguard | |||
| or immersed in water. Do not let cable lay or trail |
|
| against electrocution. | |||
| through pools of water or splashed with water from |
|
|
|
|
|
|
| hose pipes. |
| If your product is hard wired i.e. |
| |||
|
| mains electric cable, a conversion kit and exten- |
| ||||
MAINS PLUG REPLACEMENT - IMPORTANT |
|
| |||||
• | If the plug supplied is cut off it should be destroyed. |
| sion cable is available from all Approved Service |
| |||
| There is an electric shock hazard if a cut off plug is in- |
| Centres which can be found in your local Yellow |
| |||
| serted into a 13 amp socket. |
| Pages. |
|
|
| |
|
|
|
|
|
|
|
|