Removing and Fitting the Blade
Switch off, wait until the blade has stopped rotating and disconnect from the mains electricity supply BE- FORE attempting to remove or refit the blade. Always handle the blade with care - sharp edges could cause injury. USE GLOVES.
Removing the Blade
1.To remove the blade bolt, hold the blade firmly with a gloved hand and with a spanner, loosen the blade bolt by turning it
2.Remove the blade bolt, washer and blade.(S)
3.Inspect for damage and clean as necessary.
4.In the event of a blade becoming difficult to remove, insert a screwdriver (T1) into the hole (T2) to lock the drive, then use a spanner (13mm A/F) to loosen the blade bolt by turning the spanner
turn on the machine.
Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condi- tion. If the blade is cracked or damaged replace it with a new one.
Fitting the Blade
1.Fit the blade to the shaft with the sharp edges of the blade pointing away from the shaft and you are able to read the text on the blade ʻThis side to grassʼ
2.
3.Hold the blade firmly with a gloved hand and tighten the blade bolt firmly with a spanner . Do not over tighten.
S
blade bolt
washer
blade
T
1
2