Ferris Industries 5900629, 5901170, 5900625, 5900624, 5900619 manual Parking Brake Adjustment

Page 41

PARKING BRAKE ADJUSTMENT

1.Disengage the PTO, engage the parking brake, stop the engine and remove the ignition key.

2.Raise the seat plate.

3.Locate the brake spring (A, Figure 33).

4.With the parking brake engaged, measure the compressed spring length. The spring should be 1-15/16” - 2” (4,9 - 5,1 cm) when compressed.

5.If the spring is not within this range, release the parking brake and turn the adjustment nut (B) to compress or release the spring.

6.Engage the parking brake and remeasure the spring.

CAUTION

Do not adjust the spring to be shorter than

1-15/16” (4,9 cm) when compressed. This may damage the brake mechanism.

If this does not correct the braking problem, see your Ferris dealer.

Troubleshooting, Adjustment & Service

Figure 33. Parking Brake Adjustment

A.Brake Spring

B.Adjustment Nut

Troubleshooting

Image 41

Contents Ferris Industries DescriptionModel Number Date Purchased Table of Contents Operating Safety Slope Operation Roll Bar Use Fuel and Maintenance Preparation OperationTraining Towed Equipment RIDE-ON Units Slope OperationChildren EmissionsSafe Handling of Gasoline Service and MaintenanceMaintenance and Storage Operational Warnings Roll BAR InstructionsInspection and Maintenance of the Roll BAR Seat Belt Identification Identification NumbersSafety Decals Safety DecalsOperational Safety Checks Safety Interlock SystemNorth American Safety Icons Ignition Switch Seat Adjustment LeverAIR Cooled Models only Control FunctionsHour Meter / Maintenance Reminder PTO Power Take Off SwitchParking Brake Throttle ControlLiquid Cooled Models only Water Temperature Gauge Never allow passengers to ride on the unit General Operating SafetyChecks Before Starting Pushing the Rider by Hand Starting the EngineStopping the Rider Smooth Travel Zero Turn Driving PracticeForward Travel Practice Reverse Travel PracticeExecuting an End-Of-Row Zero Turn Practice Turning Around a Corner Practice Turning In PlaceExecuting Turns TurningMowing Recommendations MowingHeight of Grass Tall Grass Requires Incremental CuttingMowing Methods When and How Often to MowMowing Patterns Proper Broadcast MowingProper Mulching Attaching a TrailerTo lower the roll bar Raise & Lower the Roll BARTo raise the roll bar Keep roll bar in the raised position and use seat beltStarting After Long Term Storage StorageTemporary Storage 30 Days Or Less Long Term Storage Longer Than 30 DaysRider Maintenance Safety ItemsEngine Maintenance Before Every Spring Each 100 250 Fall Use HoursChecking / Adding Fuel Check Tire PressuresFuel Filter Change OIL & FilterChange Hydraulic OIL Filter Check Hydraulic OIL LevelAir Cooled Models Liquid Cooled ModelsPressurized System Change Engine Coolant Clean Radiator & ScreenCheck Engine Coolant Level Grease LubricationOil PivotsCleaning the Battery and Cables Liquid Cooled Models Battery MaintenanceCleaning the Battery and Cables Air Cooled Models Removing the Blade Servicing the Mower BladesTroubleshooting the Rider Troubleshooting WarningRider Troubleshooting Troubleshooting the MowerStreaking Troubleshooting Common Cutting ProblemsSpeed Balancing Adjustment Seat AdjustmentGround Speed Control Lever Adjustment RETURN-TO-NEUTRAL Adjustment Neutral AdjustmentAdjustment Linkage Rod RH side shownParking Brake Adjustment Brake Spring Adjustment Nut Parking Brake AdjustmentTo adjust the upper mounting position Suspension AdjustmentTo adjust the spring pre-load To adjust pedal position Mowing Height AdjustmentFoot Pedal Adjustment Outer Rod Deck Lift ROD Timing AdjustmentInner Rod 4 Locations Deck Leveling AdjustmentDeck Lift Spring Hydraulic Pump Drive Belt Replacement Deck Mower Belt ReplacementChecking Battery Voltage Battery ServiceCharging a Completely Discharged Battery Jump Starting With Auxiliary Booster BatteryJump Starting This HOOK-UP for Negative Ground VehiclesMake Certain Vehicles do not Touch Engine DimensionsChassis TransmissionsFerris Limited Warranty Mower Deck Belts and BladesTractor