Hayter Mowers 401C001001 manual HOW to Raise the Handle, HOW to Attach the Guard

Page 9

ASSEMBLY

HOW TO RAISE THE HANDLE

1.Hold the handle with one hand and loosen both handle adjustment knobs until the ratchet teeth are disengaged. Do not remove the handle adjustment knobs. See Figure 2.

2.Raise the handle to the

	operating position.
	3. Stand in the operator’s		Handlebar
	position behind the ma-

	chine. Put the handle in
	a comfortable position.		Rope
	Make sure both sides of
			Guide
	the handle are level.

	NOTE: Make sure the
	cables are not caught		Recoil Start
	between the upper and
			Handle
	lower handle.
			Handlebar
	4. Tighten the handle ad-
			Pivot
	justment knobs. Make

	sure the handle pivots
	are locked in place.		Handlebar
	NOTE: The handlebar
			Adjustment Knob
	height is	adjustable.
	See “How	To Adjust
	The Height Of The Han-
	dlebar” in the Mainte-
	nance section.		Figure 2

5.To attach the recoil start handle to the rope guide, twist the rope through the rope guide mounted on the right side of the handlebar.

HOW TO ATTACH THE GUARD

1.Attach the guard to the machine with the four fasteners as shown. See Figure 3.

Fastener Trimmer

Guard

Figure 3

F-050202L

9

Image 9

Contents Power Trim Table of Contents Hayter Limited Limited WarrantySafety Precautions Safety RulesResponsibility Of The Owner General OperationService ChildrenSlope Operation Never run an engine indoors or inside a closed area Control And Operating Pictorials Safety Warning PictorialsAssembly Assembly Contents of Parts BAGTo Remove the Trimmer from Carton HOW to Attach the Guard HOW to Raise the HandleEngine Preparation Fill Crankcase With OilFill Fuel Tank With Petrol HOW to Stop Trimmer Head Know Your PowertrimHOW to Stop the Engine OperationHOW to USE Trimmer Head Drive Lever HOW to USE Throttle ControlHOW to USE Primer Button Trimmer Tips HOW to Start the EngineMaintenance Product SpecificationsCustomer Responsibilities How To Lubricate Jackshaft AssemblyHow To Change Engine Oil Spark Plug HOW to Adjust the Height of the HandlebarHOW to Change Trimmer Lines Service and Adjustment HOW to Replace the Trimmer LineHOW to Replace the Drive Belt Storage TrimmerEngine Trouble Cause Correction Trouble Shooting ChartEngine will not stop Code 407C Key Description Code 407C Code 407C 050202L 050202L How To Order Replacement Parts