Hayter Mowers 185E XR16 manual Adjusting the Cutting Height, Flexiblade Replacement, Before Mowing

Page 16

OPERATING THE MOWER

Adjusting the Cutting Height

2

305113

1 = HIGH

2 = MID

3 = LOW

2

1

3

HAY-G00143-A

The cutting height of your mower has been set at the highest position (1). If you prefer a lower cut follow these instructions:

a.Turn the petrol tap to the off position and where fitted the vent screw.

b.Disconnect the spark plug lead.

c.Tilt the mower to its side. (Keeping the carburet -tor uppermost).

d.Remove flexiblade from cutting disc.

e.There are 3 different cutting height settings. Position one length of flexiblade into the desired cutting height setting. Ensure that a second length is positioned in the corresponding cutting height on the opposite side of the cutting disc.

If using spare reel of flexiblade, cut to the length of 200mm and fit as above.

Flexiblade Replacement

Drain the fuel by running the engine until the fuel tank is empty and the engine stops. Remove the spark plug lead and allow the engine to cool. Turn the mower on its left hand side and ensure that the carburet- tor is uppermost.

Wearing protective gloves remove flexiblade and replace with new.

Before Mowing

To prevent accidents, thoroughly inspect the area and remove all objects which when contacted by the mower cutterbar could become dangerous projectiles. Inspect the area for hidden obstructions which when contacted by the cutterbar could risk health and safety or result in damage to the mower. Remember the location of these obstructions and ensure that you mow around them.

1.16

Image 16
Contents Hovertrim Page Main Features Main Features SpecificationsSpecifications Page Contents Introduction Warranty Limited WarrantySafety Precautions Safety Alert SymbolTraining PreparationOperation Maintenance & Storage Stop the engine and disconnect the spark plug leadSafety Symbols Information SymbolsDelivery Checklist Assembling the MowerAssembling Lower Handlebar Upper HandlebarBefore Starting the Mower Prevent Engine DamageOil Type Check Oil LevelControls Operating the MowerStarting Step Cutting Grass StoppingFlexiblade Replacement Adjusting the Cutting HeightBefore Mowing Carburettor Adjustments Mower MaintenanceEngine Air Cleaner Service Spark Plug ServiceKeeping Engine Clean Deck HousingOil Service Securing Nuts & BoltsStorage Change the engine oilDeclaration of Conformity EC Declaration of ConformityTrouble Shooting Problem Possible Fault RemedyTrouble Shooting Mainframe Parts List Item NoteMainframe Parts List Page Customer Information Hayter Limited