Installation & Operation Manual | Infrared Electric Patio Heater | Heat Controller |
|
|
|
WARNINGS
This electric appliance produces infrared heat and failure to follow warnings and
instructions can cause a fire or injury.
READ AND SAVE THESE INSTRUCTIONS!
WARNING
FIRE OR EXPLOSION HAZARD
•Failure to follow safety warnings exactly could result in serious injury or property damage.
•Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this appliance.
•Do not store any of the following flammable materials on, or allow them to come in contact with, the unit: rags, fabrics ,spray or aerosol cans, cleaning compounds, plastics or plastic containers, paper products, gasoline, kerosene, lighter fluid.
•Do not install the heater close to furniture, curtains or other flammable items. Allow at least 36 inches (1 meter) between the heater and flammable items.
•Do not cover or otherwise obstruct the heater.
WARNING
PERSONAL INJURY HAZARD
•Do not touch the heater during operation. Burn or scald injury could result.
•Keep children away from the heater. Never leave an unsupervised child near the heater.
•Because of injury risk, the heater should be operated only by individuals knowledgeable about the operation and familiar with the warnings and cautions listed in this manual.
•Because of injury risk, this heater is not intended for use by persons with reduced physical, sensory or mental capabilities.
WARNING
PERSONAL INJURY HAZARD–SERVICE
•To avoid property damage, personal injury or death due to electrical shock, do not service the unit without first unplugging the unit from the wall outlet and allowing adequate time for the unit to cool down.
•Service must be performed only by a qualfied service technician.
•Do not use the heater if the power cord is damaged. Contact an authorized servicer or electrician to replace the cord prior to use.
WARNING
INSTALLATION & USE
To avoid property damage, personal injury or death due to electrical shock, all instructions in this Installation and Operation manual.
•All local, regional and national electric codes and local construction codes must be observed in the installation of the heater.
•The power outlet must be properly polarized and grounded.
•Be sure the voltage listed on the heater’s nameplate is the same as the voltage at the installation site.
•Do not use the heater if the power cord is damaged. Contact a qualified service agency or electrician to replace the cord prior to use.
•Remove the plug from the power outlet and wait until the heater is sufficiently cool before cleaning it.
CAUTION
•Never use with an extension cord or
•Use extreme caution whenever the heater is left operating and unattended.
•Do not install the heater immediately below a wall socket outlet.
•Do not use a timer or other device that automatically turns on the unit.
•Do not use the heater with an external voltage regulator such as a dimmer or speed controller.
2