Hunter Fan 42637-01 installation manual Steps 7-1

7 • Completing Your Installation With a Multi Staked Light Fixture

Steps 7-1 – 7-3

Housing

Assembly Upper

Screw Switch

Housing

WARNING: Use only the light fixture supplied with this fan model.

7-1. To attach the upper switch housing, partially install two #6-32 x 3/8” housing assembly screws into the switch housing mounting plate.

7-2. Align the keyhole slots in the housing with the housing assembly screws.

7-3. Turn the housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. Install the remaining #6-32 x 3/8” screw into the housing. Tighten all three screws firmly.

CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the switch housing fixture falling.

7-4. To attach the lower switch housing, connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly.

Plug

Connector

Lower

Switch

Housing

Step 7-4

Note: Both plug connectors are polarized and will only fit together one way. Make sure the connectors are properly aligned before connecting them. Incorrect connection could cause improper operation and damage to the product.

7-5. Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing with three #6-32 x 3/8” housing assembly screws.

Housing

Assembly Screw

Plug

Connector

Detail

10

42637-01 • 02/10/09 • Hunter Fan Company