Husqvarna 136, 141, 136LE, 141LE instruction manual Chain Brake Assembly

Page 2

																					1
					1				2			3						6
																		6			7

															12			5
20																		5
20
																		4
19			8
		18		17				16			22			15		14		13				9
		18									22			15		14		13		11	10


														23					24	21
																				21

1.		Cylinder Cover																13.	Bar Tip Sprocket
2.		Front Handle																14.	Saw Chain
3.		Front Hand Guard																15.	Saw Bar
4.		Starter Cover																16.	Chain Catcher
5.		Chain Oil Tank																17.	Chain Brake Assembly
6.		Starter Handle																18.	Rear Hand Guard
7.		Carburetor Adjusting Screw																19.	Throttle Control/Trigger
8.		Choke Control																20.	Throttle Lock
9.		Rear Handle																21.	Bar/Chain Adjustment Tool
	10. ON/OFF Stop Switch																	22.	Chain Tensioning Screw
11.		Fuel Tank																23.	Instruction Manual
	12. Muffler																	24.	Guide Bar Cover

WARNING! This chain saw can be dangerous! Careless or improper use can cause serious or even fatal injury.

Read and understand the instruction manual before using the chain saw.

XX_

Measured maximum kickback value without chain brake for the bar and chain combination on the label.

Sound pressure level at 15 meters (50 feet)

There may be more symbols found on your unit other than those listed above. These symbols may represent compliances, standards, or other matters concerning the product.

2

Image 2

Contents 136 530163874 6/18/03Chain Brake Assembly Maintain Your SAW in Good Working Order Plan AheadOperate Your SAW Safely Handle Fuel with CautionMaintain Control KickbackReduce the Chance of Kickback Avoid Pinch-KickbackElbow locked Thumb on underside of handlebar Kickback Safety FeaturesChain Brake and CKA Angle Standards Safety Notice Exposure toComputed kickback angle CKA Table Checking the tension Chain Tension Including units with chain already installedAttaching the BAR & Chain If BAR and Chain Lubrication Adjusting the tensionFueling Engine Guide Bar Chain Brake NutsChain Brake Important points to rememberStarting a Warm Engine Important Points Braking function control Caution The chain brake must beInertia activating function control Tree Felling TechniquesTypes of Cutting Used for Bucking Notch CUT and Felling the TreeCutting a Fallen Tree Use a wedge to remove pinched sawLimbing and Pruning Important Points Bucking Using a LOG or SUP- Port StandBucking Without a Support LimbingBAR Maintenance Cleaning the air filterCarburetor Adjustments AIR FilterSpark Plug Chain SharpeningIgnition Timing StorageLoad Adjustment Engine Troubleshooting Table Cause RemedyLimited Warranty Year NON-COMMERCIAL Warranty AuProcedure to OB- Tain Warranty Consideration HUSQVARNA’S OB- Ligations Under the WarrantyItems not Covered by this Warranty Exceptions and LimitationsMaintenance Statement The owner Ligations The U. S. EnvironmentalIntermediate 125 hours Extended 300 hours