ON/STANDBY | ON/STANDBY | Remote | SOURCE | MASTER VOLUME |
button | indicator | sensor | button | buttons |
R L
DVD IN
AUX IN
OUTPUT
LEFT
FRONT
RIGHT
LEFT
REAR
RIGHT
+
T 1.25AL/250V
POWER switch
AC power plug
SPEAKER TERMINALS 4
General
1 After completing all SPEAKER and AUDIO connections, plug the AC power plug into a 120V 60 Hz wall outlet and flip POWER switch on the back of the main set to ON position, the system enters STANDBY mode and the ON/STANDBY indicator will flash in red. This plug is polarized, if it does not fit your outlet, do not force it, reverse it and
2 Press the ON/STANDBY button on the front of the main set or on the REMOTE CONTROL to turn the system on and the ON/STANDBY indicator will be steadily on in green.
NOTE: The ON/STANDBY indicator has 3 modes: flashing in red and in green, and steadily on in green (slow flashing in red indicates the set is in standby mode; Flashing in green indicates confirming you pressed any button on the main set or on the remote control and steadily on in green indicates the set is on). When the set is on, pressing the ON/STANDBY button on the main set or on the REMOTE CONTROL will turn the set to the standby mode, the indicator will become slow flashing in red.
3 Press the SOURCE button on the front panel of the main set or on the REMOTE CONTROL repeatedly to select your desired audio input sources and the sound will be heard from the HOME THEATER SYSTEM.
4 For SUBWOOFER’s volume adjustment, press the SUBWOOFER volume control buttons on the Remote control:
+raises the volume, and the ON/STANDBY indicator will flash in green, but at its maximum level, the ON/STANDBY indicator will stop flashing.
–lowers the volume, and the ON/STANDBY indicator will flash in green, but at its minimum level, the ON/STANDBY indicator will stop flashing.
Follow this step to adjust the FRONT, CENTER and REAR speakers as well.
5 For MASTER’s volume adjustment (change all the speaker’s volume at the same time), press the VOLUME + or VOLUME – button on the main set or the MASTER VOLUME control 
or 
on the remote control.
raises the volume, and the ON/STANDBY indicator will flash in green, but at its maximum level, the ON/STANDBY indicator will stop flashing.
lowers the volume, and the ON/STANDBY indicator will flash in green, but at its minimum level, the ON/STANDBY indicator will stop flashing.
6 To adjust all speaker’s volume to the factory’s default settings, press the RESET button.
NOTE: Every time you turn the set on, the MASTER VOLUME will go back to the factory’s default setting; and whenever you press the SOURCE button on the main unit or the SOURCE button on the REMOTE, the MASTER VOLUME will go back to the factory’s default setting. This avoids sudden very loud sounds from startling you.
11 |
|