Husqvarna 970, 850 manual Maintenancee, Maintenance schedule, Daily Maintenance interval

MAINTENANCEE

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which are not described in these instructions go to an authorised service workshop.

		Daily	Maintenance interval
Maintenance	Page	mainten-		in hours
		ance
		before start	25	50	100
Check the engine’s oil level	21	●
Check the engine’s cooling air inlet	21	●
Check the fuel pump’s air filter	21	●
Check the steering wires	22	●
Check the brakes	23	●
Check the battery	23	●
Check the safety system	23	●
Check screws and nuts	–	❍
Check for fuel and oil leakage	–	❍
Clean the air filter’s pre-filter (foam plastic) 2)	24		●
Check the cutting unit	25		●
Check the tyre pressures (60 kPa)	28		●
Change the engine oil1)	29		●
Adjust the brakes	23		●
Check the V-belts	–		❍
Lubricate joints and shafts 3)	29			●
Check and adjust the throttle wire	30			●
Clean the engine’s cooling flanges 2,4)	–			❍
Replace the air filter’s pre-filter and paper filter 2)	24				●
Replace the fuel filter	30				●
Replace the plug	–				❍

1)First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.

●= Described in these instructions.

❍ = Not described in these instructions.

! WARNING!No service procedures must be conducted on the engine or cutting unit unless:

• The engine is switched off.		•	The parking brake is applied.
•	The ignition key is removed.	•	The cutting unit is disengaged.
•	The ignition cable is removed from the plug.

English – 19